3524SRW Magic Chef Range - Instructions

Simple repair.Just make sure you measure the length of element from back wall to plug in,width,and width of holes in back of oven.Simple repair with correct measurements.Pluged it in replaced screws plugged power back to unit , worked like a charm....Thank You!!!

Power off by unplugging appliance!
Remove the old element by removing one screw from each of the old element anchoring tabs.
Pull element away from back of oven approx. 3 inches to expose spade lug electrical connectors.
With the pliers, gently seperate the spade connector from the element connecting tab.
Remove old element.
Install new element in reverse order.
Plug appliance in, set oven to warm/low heat to test and burn off any metal preserveative from elemnt surface.
Check operation by allowing to heat for < 30 seconds. Oven element should start to warm and can be confirmed by breifly placing hand a few inches away from element to detect heat.
Turn oven off if satisfactory. Reset time on oven clock. Finis!!!!

unscrewed covers . unpluged heating element , pluged in new one , put covers back on. oh yeah unplug stove first.

Replaced the element.

I removed the element from the back of the oven.Then i removed the wires from the bad element. I then attached the wires to the new element,and screwed it into place.

Watched the video provided and followed the instructions. I couldn't believe how simple it was to fix the problem! I ordered the part Sunday evening and it was sitting in front of my door Tuesday afternoon. Talk about service! I couldn't be more pleased with the convience of fixing my problem right from my own home. Thank You!

Disconnect the electrical cord, remove the oven racks, remove the screws holding the bake element with a screw driver, pull out the bake element, then replace it with the new element. Done!

1. Turned off electricity to oven.
2. Unscrewed old oven element. Found it had burned through
on the underside.
3. Inserted & screwed in new oven element.

35 year old oven good to go.

unscrew 2 screws, pull 2 connectors off, put in new part in reverse order - easy fix.

Removed old element (two screws) unclipped two wires. Clipped the two wires to the new element (one at each end), reinserted new element, replaced the two screws. Done. Oh, flipped the circuit breaker back on:-)

unscrewed the old baking element, took the yellow wire off, and put the yellow wire onto the new baking element and screwed it back onto the oven. Took less than 15 minutes.

This was a snap. It took me longer to find the right part number than it did to make the repair. After securing power to the oven, I removed the racks. I then unscrewed the element supports and pulled the element out slightly to expose the connectors. Using a pliers I removed the connector from each side of the element. At this point, I should have placed a piece of electrical tape to prevent the connector leads from slipping back into the body of the oven. Instead, I fished them out with a tweezer, and slid the connectors back onto each side of the element. I then screwed in the elements supports, replaced the oven racks, and restored the power. It literally took less than 10 minutes.

Super simple. My husband ordered the part. It arrived in 3 days. The old element plugs right into cables on both sides of the back of the oven and are secured to the rear wall with screws. I unscrewed the plates, detached the wires on each side and slid the new ones in place. It was that easy and took me about 10 minutes.

We repalced the heating element n no time. Easy to do and the price couldn't be beat!

Followed the instructions exactly as described on the Parts web site video, shut off power, removed old baking element, checked connectors, replaced with new element, turned power back on to the range. Repair took less than 15 minutes.