3523WRV Magic Chef Range - Instructions

removed drawer from track replaced supports on track and one on the drawer.

Called repairman, he never called back for a week. Gave up and found your website, ordered the part. You said it would take 3-5 business days. You lied, it was there the next day. Taking old element out starts with shutting off the juice. Remove trays, pans, etc. Unscrew two screws, pull out elements ends, unclip from wires, reverse the process with new one. You need a light to do this.

the new elements were super easy to replace. the old ones just pulled out and the new ones easily pushed in. the top one was a little more difficult only because it had brackets that had to be slid of and then slid onto the new one.

Broken part was already removed, so I used the screw from the broken support and installed the new support. Very simple, easy, and painless.

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires reverse the order to install the socet was easy but after i was done discovered that the base of the old bulb was stuck in the socet keeped it for future use

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

replaced burner element

Unscrewed 2 holding brackets. Removed old element. Unfortunately one clip broke off the wire and had to be replaced. Attached clips to element and replaced holding brackets.
Job is simple but working in the oven without damaging the oven door requires a younger back.
Without problems should take ten minutes.

Turned off the breaker to the stove. Removed the screws holding the old parts in and unplugged the element. After reshaping the element because it got damaged in shipping I plugged the wires to the new element, replaced the screws and turned the breaker back on. Tried the stove and it has worked fine since.

Pretty simple, except the element melted very close to one end, so the screw holding the element to the rear of the stove was partly melted also. Had to drill it out & used a nut & bolt to secure the new element.
Apart from that, it was a breeze. As others have done, I re-tightened the lugs that the element plugged into.
Suggest a "test heating" before using stove: mine had a strong odor on first use, fine afterwards

Repair went fine as I read on how to do it and it worked fine. Hardest part was hitting the hole for the screws.

It would've been so much easier if replacement instructions were included. Replacement screws would've been nice also

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires attached to the element, reattached to new element and replaced screws. This was very easy, I was glad I did not call the repairman.

First I turned OFF the elect power to the stove.
Then I got a flash light to see into the oven. removed the two screws, anf pulled the element out far enough to disconnect the two wires.
Put the connecters on the new element pushed it back put the two screws back.
Turned the power on works great, very easy.

Repair is really easy. Just remove two screws, pull ( gently ) on the bake element until you see the electrical connectors. Remove and do the reverse with the new part. Oven works just fine.
Really Really easy....