CLY2220BDB Magic Chef Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Jimmy from Texarkana, AR
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
oven rack missing
Odered rack on internet. Received in timely manner. Was the correct oven part. Very satisfied. Thank you.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Wendi from Cypress, CA
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I needed an additional rack for our RV oven
After some research in finding the information under the range hood, I did internet searches to find the appropriate replacement rack.
It fits great and we are thrilled to have the additional rack.
It fits great and we are thrilled to have the additional rack.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from ROCKPORT, TX
- Parts Used:
- WP7515P046-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Wrench set
Worn thermostat
Turn off the gas. Lift the range top. Disconnect the gas lines. Remove the knob and the old thermostat. Reverse the steps and turn on the gas. Check for gas leaks.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Willi from Old Saybrook, CT
- Parts Used:
- WP7112P004-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Thermostat bulb was hanging loose
Removed what was left of the original clips. Pressed in the new clips and snapped in the themostat blub
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kenneth from Lakewood, NM
- Parts Used:
- 74007287
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Finish errosion
Replaced with new part
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Arlynn from Sagle, ID
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Missing oven rack
Purchased a 1999 RV discovered the oven was misssing a rack and we were unable to use.
Located the part, ordering was easy. The rack arrived and fits perfect in the oven like it was made for it.
Thanks
Located the part, ordering was easy. The rack arrived and fits perfect in the oven like it was made for it.
Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dwayne from Atlanta, GA
- Parts Used:
- WP7112P004-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
thermostat temprature bulb hanger clips
snaped them into oven cavity attached temp bulb job complete
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from Niland, CA
- Parts Used:
- 74002413, WP5111A719-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Igniter failed
The igniter on our RV stove top failed after 4 years of operation. The repair took about 8 minutes and everything works fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donna from Bushnell, FL
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
second oven rack
I was very impressed with the ease in ordering the part, and the speed of delivery. All I needed was a second oven rack so that when I bake cookies, I can bake two trays instead of one, I get done in half the time now. Thank you Part Select!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lisa from Plymouth, MA
- Parts Used:
- Y8007P02060
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rubber grommet for stove top cover
I ordered the grommet... Didn't match the others ... But it fit on , and will do the job
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jennifer from Winnsboro, TX
- Parts Used:
- WP7505P327-60
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Wrench (Adjustable), Wrench set
Pilot light went out after being lit and adjusting oven temp
I was disappointed that directions did not come with the part, as I had never before made this repair. However, I turned off the gas connection, unscrewed the oven from its place in the wall, then removed the racks in the oven. Next, I loosened the nuts and screws of the pilot assembly in the oven and loosened the connection on top under the stove. Behind the stove, the copper wire of the thermocouple was fastened together with the others, so I disconnected that and removed the assembly. Next, I uncoiled the new copper thermocouple wire and fed its stove connection through the top rear of the stove, fit it to the connection, and tightened it. Then I fed the other end (with the pilot) through the back of the stove and connected it to the pilot brace. Tightened nuts into place, replaced oven racks, and screwed oven back into the wall. Turned on the gas, lit the pilot, and it immediately lit the stove! I would really have preferred directions, though. I felt intimidated by the whole thing, doubting myself as I made every step. So many ways to screw up...
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larry from Casa Grande, AZ
- Parts Used:
- 74003929
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Oven door handle broke in two pieces
Remove two black Phillips head screws from the top of the oven door and two black Phillips head screws from the bottom of the oven door which releases the door from the oven. Remove the two Phillips head screws that hold the handle and discard broken handle. Install new handle onto door and then replace the door. Easy!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Henry from Omaha, NE
- Parts Used:
- Y8007P02060, 74003944, 74003327
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Front flashtube extension rusted through, ignition knob stripped, rubber grommet missing
Removed screws from igniter cover, removed and replaced fron extension tube. Removed old knob and replaced. Replaced missing grommet. Saved other extension tubes as the old ones were still serviceable.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from Richwood, OH
- Parts Used:
- Y8007P02060
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
original grommets broken
The new grommets were NOT the correct parts, too big, so there was no repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Harvey from Lynchburg, TN
- Parts Used:
- 74003944
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Knob would not turn igniter.
Simple off/on installation.
Was this instruction helpful to you?
Thank you for voting!