C3542XRW Magic Chef Range - Instructions

Removed back of stove (6 screws), puled clips loose. Two screws inside oven, pulled out old element. slid new one in, replaced screws, slid on clips replaced back panel. Don't forget to unplug the stove frist.

Took out 2 screws pulled off the 2 female connectors. put the conectors on the new element and put the screws in. It took less than 10 minutes

This was a snap. It took me longer to find the right part number than it did to make the repair. After securing power to the oven, I removed the racks. I then unscrewed the element supports and pulled the element out slightly to expose the connectors. Using a pliers I removed the connector from each side of the element. At this point, I should have placed a piece of electrical tape to prevent the connector leads from slipping back into the body of the oven. Instead, I fished them out with a tweezer, and slid the connectors back onto each side of the element. I then screwed in the elements supports, replaced the oven racks, and restored the power. It literally took less than 10 minutes.

Super simple. My husband ordered the part. It arrived in 3 days. The old element plugs right into cables on both sides of the back of the oven and are secured to the rear wall with screws. I unscrewed the plates, detached the wires on each side and slid the new ones in place. It was that easy and took me about 10 minutes.

We repalced the heating element n no time. Easy to do and the price couldn't be beat!

Two screws out, the old bake element came out easily, was able to disconnect very easily from the clip wiring, then replaced with new. I even was able to replace the oven light bulb at the same time. A real cinch.

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires...)

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires, at that point I attempted to reconnect the two wires, that is when I found out why they tell you to unplug the electricity. It wasn't a big shock, more of a consistant shock. Once I unpluged the stove from the wall, it only took about 3 minutes or so to connect the wires and replace the two screws. I have no doubt I saved a hundred dollars doing this myself.
Thank you for your prompt delivery on the replacement part for my Bake Element at what I felt was a very reasonable price.

. First I removed the two screws that hold the ace. I thenelement in place. I then pulled the element out about inches and disconnected the two wires...)

I unplugged the oven, sat the flash light in the oven and removed the two screws that hold the element in place. I pulled the element out and diconnected the two metal wire clasps from the element. Connected the new element, made sure the clasps were secured. Slid the wires back in and replaced the screws. Tested the oven, it heats up to correct temperature. I am a women and it was real easy thanks to the other repair stories I read.

Remove the bottom rack from the oven. Pull the heating element straight back and out of the oven. Inserted the replacement burner in the opposite manner. Part was delivered in a timely manner.

It would've been so much easier if replacement instructions were included. Replacement screws would've been nice also

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires attached to the element, reattached to new element and replaced screws. This was very easy, I was glad I did not call the repairman.

Unscrewed two screws holding element in place and pulled off the electrical wires to the element.( be sure to remove power to the stove)Put wires on new element and installed screws back in. Done

Shut off electricity to appliance then unpluged wiring from old element and pluged in new element.