Models > 3521WRV > Instructions

3521WRV Magic Chef Range - Instructions

Jump to:

All Instructions for the 3521WRV

Customer:: Edward from Adamstown, MD
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Pliers, Screw drivers

No Bake, only Broil

POWER OFF! Unplugged oven from wall.

(Note: I found it easier to disconnect the wires from the element by removing the rear cover. Fumbling around inside the oven was getting me nowhere.)

Removed rear cover.
Disconnected old element.
Unscrewed the old element from inside the oven, removed, and installed the new element. Screwed the new element in place.
Reconnected wires in back, installed the back cover.
Connected power.
Tested. Good as new.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Betsy from Sun City, AZ
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Previous element burnt up

I let my husband to the work...But it was very easy. I could have done it! He removed the screws, pulled the wires off previous element. Reattached the wires to the new element and screwed the ends back in place.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Jackie from Hughes Springs, TX
Parts Used:: WPY04000035
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

burner would not heat.

I unpluged the old burner and pluged the new one in. Repair done in about 2 min,

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Raymond from Ottawa, OH
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Element burned out.

First I removed the two screws that hold the element in place. I then pulled the element out aobut 3 inches and disconnected the wires.

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Paul from Yukon, OK
Parts Used:: WP74003019
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

snapped element

switch off the range. undo the two screws & unplug the two tabs. Replace with new element, connect two tabs, screw back in place. done!
recieved my replacement part the next day after ordering

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Marion J. from Palmetto, FL
Parts Used:: W10196406RW, WPW10196405
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

replacing old drip bowls

It was so simple & the parts fit perfectly. I appreciated all the help from your sales lady. Thanks again.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: James from Allyn, WA
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Element burned in half

Took two screws out unplugged the element and plugged the new one in and replaced the screws and turned the breaker back on. Works great...Piece of cake..jk

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Hudson from Cockeysville, MD
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

The element was completely gone.

Turned off power, removed 2 screws, un-hooked the connections, them put in the new element in reverse order.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Bert from S. Easton, MA
Parts Used:: WP74003019
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Bake Element Melted

Unplugged stove, unscrewed element pulled element out about 3 inces and disconnected element. Took model of stove looked on line for part. PartSelect had the best price and easiest web site to order part. Ordered part about 4pm and received part in 2 days. Took element out of box plug into connections and screwed the element back in. Plugged stove in and worked perfect.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Leticia from Sunnyvale, CA
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

bakeing element caught fire.

First I turned off power to the range at the fuse box (very important-The last time I didn't do this and ended up paying a repairman $150.00 to replace the damaged connectors). I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. I then connected the new element, pushed the element back in and replaced the screws. Turned the power back on and tested the element. The whole job took about 30 minutes because I had trouble disconnecting the old element. I used the flat end of the scrapper to push against the connector while I pulled the element out. Normally it would take only about 15 minutes.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Wayne from Marietta, GA
Parts Used:: WP74003019
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Element burned out.

Turn off breaker.
Unscrew old element, disconnect wires.
Connect wires to new element, tighten screws.
Breaker back to ON.
Done.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Shelly from Allentown, PA
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

fireworks in the oven. Burned completely in two.

My husband has moved out of state for his job. I am left here with the children until the house sells. This is the first time I have ever had to do any oven repair. I had excellent and fast service - my part came right away. I took out the 2 screws holding the element in place, pulled the element out, disconnected the old element, connected the new one, pushed it back in, and replaced the screws. No problem at all. I was a little nervous turning it all back on, but it is working perfectly!

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: TONI from SALISBURY, NC
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Pliers, Screw drivers

element had cracked

First I cut the power to the stove. Then I unscrewed the two screws. Pulled the element out a few inches. I had to use pliers to disconnect it from its wires. It was a very tight fit. Then I reconnected the new element. Cut the power back and and fired her up. Boy did she burn like fire.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: John from Overton, TX
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Pliers, Screw drivers

element burnt into.

The part came quick and packed very well. I moved the stove out and un pluged it. opened oven door and took a philips screwdriver and took the screws out at the back of element..Slid it out with the two wires attached and unpluged the conectors. pluged the conectors on to the new element and slid it back in. Had a chocolate cake in 35 minuts.
Thanks, John in Texas

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: burton from prides crossing, MA
Parts Used:: WP74003019
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

hot spot in center of bake element appeared suggesting failure was imminent

pulled breaker,removed oven door,removed 2 screws,pulled bake element out 3 inches,pulled connections off,pushed connectors on new element,pushed new element back and replaced screws,replaced oven door ,pushed breaker back and turned on oven and let it heat up to 350 degrees.
Total time 10 minutes,even a caveman could do it.

1 person found this instruction helpful.

Was this instruction helpful to you?

All Instructions for the 3521WRV