3527XRW Magic Chef Range - Instructions

removed drawer from track replaced supports on track and one on the drawer.

Called repairman, he never called back for a week. Gave up and found your website, ordered the part. You said it would take 3-5 business days. You lied, it was there the next day. Taking old element out starts with shutting off the juice. Remove trays, pans, etc. Unscrew two screws, pull out elements ends, unclip from wires, reverse the process with new one. You need a light to do this.

Removed unit from counter, removed 14 screws holding glass top to frame, removed ceramic element, swapped over mounting brackets to new element, checked wireing as per instruction sheet (direct replacement) connected wires, re-installed glass top to frame and placed back into counter. ops check good.

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

Pretty simple, except the element melted very close to one end, so the screw holding the element to the rear of the stove was partly melted also. Had to drill it out & used a nut & bolt to secure the new element.
Apart from that, it was a breeze. As others have done, I re-tightened the lugs that the element plugged into.
Suggest a "test heating" before using stove: mine had a strong odor on first use, fine afterwards

Unscrewed 2 holding brackets. Removed old element. Unfortunately one clip broke off the wire and had to be replaced. Attached clips to element and replaced holding brackets.
Job is simple but working in the oven without damaging the oven door requires a younger back.
Without problems should take ten minutes.

replaced burner element

Turned off the breaker to the stove. Removed the screws holding the old parts in and unplugged the element. After reshaping the element because it got damaged in shipping I plugged the wires to the new element, replaced the screws and turned the breaker back on. Tried the stove and it has worked fine since.

It would've been so much easier if replacement instructions were included. Replacement screws would've been nice also

Repair went fine as I read on how to do it and it worked fine. Hardest part was hitting the hole for the screws.

Removed old coil by unscrewing the element and unplugging it from the wires, adjusted the terminal slightly and plugged in the wire from the new element.

It was a very simple process and would have taken me less time if I wasn't so old and couldn't bend easily!

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires attached to the element, reattached to new element and replaced screws. This was very easy, I was glad I did not call the repairman.

Removed two screws and unpluged old element plugged in new element and re-attacheched to oven. No Problems at all.

Unplugged stove. Removed door. Unfastened 2 screws at rear of oven. Removed wires from bake element. Connected new bake element. Replaced screws and door. Plugged oven back in.

I ordered the part on Sunday night and it came on Wednesday. I watched the 'Partselect' video prior to doing the repair - the video got right to the repair and it gave me all the information (and confidence) I needed. It took me longer to clean the bottom of the oven than it did to make the actual repair. I can't imagine paying someone to do such an easy job. My kids had a great time playing with the bubble wrap from the box!