22RB-3BKZ Magic Chef Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Arlynn from Sagle, ID
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Missing oven rack
Purchased a 1999 RV discovered the oven was misssing a rack and we were unable to use.
Located the part, ordering was easy. The rack arrived and fits perfect in the oven like it was made for it.
Thanks
Located the part, ordering was easy. The rack arrived and fits perfect in the oven like it was made for it.
Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- gail from bethany, MO
- Parts Used:
- 74001794
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
knob worn put
easy replaced after giving proper model and serial numbers. They were very helpful sending pictures so i could choose which knob might work as they had two for the same model number. The person answering my call was very helpful. Also return of the wrong ones I ordered was easy and refund prompt. I would highly recommend this company.Gail from Mo.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kenneth from Lakewood, NM
- Parts Used:
- 74007287
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Finish errosion
Replaced with new part
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dan from Caseville, MI
- Parts Used:
- W10125661
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Wrench (Adjustable)
oven would light but not shut off at designated temp
Make sure that gas is turned offf to appliance.I had to remove the top of the range and use adjustable wrench to loosen the two gas tubes. Then use screww driver to remove valve from gas feed tube ( oh - make sure to turn of gas at apppliance gas valve). I then had to use the adjustable wrnech for removing the flange.
Caution should be used when reinstalling the tubing. Also test all jionts with soapy water.
Caution should be used when reinstalling the tubing. Also test all jionts with soapy water.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Brownwood, TX
- Parts Used:
- 12001296
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Top burners would not ignite
Removed igniter wire, 2 screws, removed old igniter and reversed procedure, checked spark
and then lit burner. Easy, Easy
and then lit burner. Easy, Easy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tim from Santa Paula, CA
- Parts Used:
- 12001296
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Ignitor shaft and knob sheered
This is a small RV cooktop. There is no pilot light but each burner will light using the spark type ingitor twist knob. Raise the front of the stove cooktop. It is on a hinge. Replace the ignitor assembly using existing screws. There is a very small anchor pin on the ignitor assy. which protrudes 1/16" from the base. The anchor pin hole had not been drilled into the stove face plate which prevents the ignitor assembly from twisting when engaged. So I drilled a 3/16 anchor pin hole exactly where required. It is important to be exact so as to align the installation screw holes in the face plate. These holes can be enlarged if need be however. Align the pin with the anchor hole and install the 2 existing screws. Attach the ignitor lead to the ignitor assy. and install the new knob. Close the stove top and start cooking.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Willi from Old Saybrook, CT
- Parts Used:
- WP7112P004-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Thermostat bulb was hanging loose
Removed what was left of the original clips. Pressed in the new clips and snapped in the themostat blub
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dwayne from Atlanta, GA
- Parts Used:
- WP7112P004-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
thermostat temprature bulb hanger clips
snaped them into oven cavity attached temp bulb job complete
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kevin from Elk City, OK
- Parts Used:
- 12001296
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Ignitor was not functioning properly.
I removed the igniter cable from the old knob. Removed 2 screws and the old knob, installed the new knob with 2 screws and plugged in the igniter cable. Works like a CHAMP!!! Must be an Oklahoma State University Football igniter and knob!! 2001 Big 12 Champions!!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from Niland, CA
- Parts Used:
- 74002413, WP5111A719-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Igniter failed
The igniter on our RV stove top failed after 4 years of operation. The repair took about 8 minutes and everything works fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Martin from Millersburg, MI
- Parts Used:
- Y8007P02060
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Lost on of the Rubber Grommet holding the stove grate
So simple would be embarrassed to give any instructions; it is so self evident.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Matthew from Vancouver, WA
- Parts Used:
- WP74002414
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rotating ignitor knob on my RV stove broke
The old knob simply slides off the shaft. I aligned the fins on the back of the new knob with the grooves on the shaft of the ignitor and pressed the new knob on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ronald from Yuma, AZ
- Parts Used:
- 12001296
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
igniter worn out
Pull off wire and outer knob. Take out 2 screws and reverse process to install new part. Easy and works fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donna from Bushnell, FL
- Parts Used:
- 74003106
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
second oven rack
I was very impressed with the ease in ordering the part, and the speed of delivery. All I needed was a second oven rack so that when I bake cookies, I can bake two trays instead of one, I get done in half the time now. Thank you Part Select!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- john from mount vernon, WA
- Parts Used:
- 74003327
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
flashtube was burned off
put in new flashtube
Was this instruction helpful to you?
Thank you for voting!