3527XUA Magic Chef Range - Instructions

Disconnected power plug,had to clean behind oven! , then...... removed 2 screws that held element in place, pulled element out about 3 inches disconnected 2 wires, removed old element, slide in new one, connected 2 wires, slide coil in carefully, and replaced 2 screws, replaced power plug checked operation, (worked fine) slide oven back into place....wife was happy.

I watched the video intructing the installation of the bake element. The one thing I would suggest is to remove the oven door as this allows someone with a shorter reach to do the repair.

Unplugged stove. Removed door. Unfastened 2 screws at rear of oven. Removed wires from bake element. Connected new bake element. Replaced screws and door. Plugged oven back in.

It would've been so much easier if replacement instructions were included. Replacement screws would've been nice also

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires attached to the element, reattached to new element and replaced screws. This was very easy, I was glad I did not call the repairman.

Removed old coil by unscrewing the element and unplugging it from the wires, adjusted the terminal slightly and plugged in the wire from the new element.

It was a very simple process and would have taken me less time if I wasn't so old and couldn't bend easily!

Unscrewed two screws holding element in place and pulled off the electrical wires to the element.( be sure to remove power to the stove)Put wires on new element and installed screws back in. Done

Removed 2 screws, should have tripped breaker first but learned the hard way, unplug wires, install new.

Shut off electricity to appliance then unpluged wiring from old element and pluged in new element.

Replaced the element.

Power off by unplugging appliance!
Remove the old element by removing one screw from each of the old element anchoring tabs.
Pull element away from back of oven approx. 3 inches to expose spade lug electrical connectors.
With the pliers, gently seperate the spade connector from the element connecting tab.
Remove old element.
Install new element in reverse order.
Plug appliance in, set oven to warm/low heat to test and burn off any metal preserveative from elemnt surface.
Check operation by allowing to heat for < 30 seconds. Oven element should start to warm and can be confirmed by breifly placing hand a few inches away from element to detect heat.
Turn oven off if satisfactory. Reset time on oven clock. Finis!!!!

Simple repair.Just make sure you measure the length of element from back wall to plug in,width,and width of holes in back of oven.Simple repair with correct measurements.Pluged it in replaced screws plugged power back to unit , worked like a charm....Thank You!!!

I figured there couldn't be much else but the element that was bad, so I searched for "Magic Chef stove parts" on Google and found your site. Your site described the location for the model number of my stove, and also gave troubleshooting tips. I verified the element was bad with an ohmmeter and ordered the part from you guys. It arrived early, and installed with 2 screws and 2 push-on terminals. Stove works great now! I'm a web programmer and I think your website is very intuitive and useful. The information like model numbers, troubleshooting, parts measurements and extensive parts pictures is perfect for your customers. I found the correct diagnosis and part quickly, and ordered without a problem. Thanks - and keep up the good work! Mike

Turn power off, lifted door of swing hinge, remove convection fan plate screws, remove screws on element bracket, remove from recess far enough to unplug connectors, reverse order to assemble.

I am really impressed with partselect.com. I ordered the part on a Saturday evening after my oven quit. By Monday evening I had an email showing it shipped and received it on Wednesday. The fit was perfect and the fix was quick.