MS1545ABS (CBKELGA) LG Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- John from Minneapolis, MN
- Parts Used:
- 5020W0A001B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The button that opened the door had plastic hooks break off.
I looked up the part number, with shipping it came to $16, and in one minute of installation time, I just gently pushed the button into the front using the original springs that pushed the button back out, and it just clicked into place, the microwave back in action.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- greg from minneapolis, MN
- Parts Used:
- 5020W0A001B, 4B72023B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
door button retaining clips broke off. button would fall out of place
Inserted spring on middle post on button back side. Pushed button/spring into hole on front of microwave until clips engaged and snaped into place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stan from New Bedford, MA
- Parts Used:
- 6549W1S011B
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Carousel would not turn. Small plastic drive shaft broken.
Pried cover off bottom-center of microwave. It seems to be either glued or lightly tack welded. Removed 2 small Phillips screws to remove motor. Disconnected electric feed by hand. Don't let go of electric wire or small screws. They will be hard to retrieve from behind the rest of the metal base. Reverse process to install new motor. Didn't try to put small cover back on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- kent from wichita, KS
- Parts Used:
- 6549W1S011B
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
the turntable on the microwave quit turning even though the microwave would heat up
I removed the outer cover of the microwave and removed the bottom palte to access the small motor. i unplugged the old motor from teh wiring connector, removed (1) screw and motor came out. I reversed the proceedure with the new motor and it was finished.It was a piece of cake.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Arthur from Windham, NH
- Parts Used:
- 6600W1K001D, 3B73361E
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Had to lift on the door for the microwave to run, suspected the door switches.
Ordered the switches from Partselect, arrive in two days. Had trouble removing the plastic connectors from the old switch terminals, one of the plastic protectors broke, but was able to reuse it. It took a little figuring out how to remove the existing switches. Must push in a tab and rotate the switch on a little pin, then remove. Must be careful not to break the plastic tabs holding the switches in place. Replaced all (3) switches at the same time. All in all it was pretty easy.
Was this instruction helpful to you?
Thank you for voting!