79091313011 Kenmore Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- carl from mashpee, MA
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
drawer glides went in with just a push with a finger ,works great
pushed the glides in the proper holes and ,they work great now ,drawer opens and closes as easy as it should. will buy from again.
Was this instruction helpful to you?
Thank you for voting!
the drawer glides were borken
I removed the brokne ones and replaced them with the new ones.
I appreciated PartSelect giving a picture of the parts so i didn't have to search for the part number.
I appreciated PartSelect giving a picture of the parts so i didn't have to search for the part number.
Was this instruction helpful to you?
Thank you for voting!
Drawer Glide Broke..
No problem..... I just had to slide the new one in..It took all of 5 minutes...
I searched so many different places for the part until a friend told me about Part Select!!!
Thank you so much...
I searched so many different places for the part until a friend told me about Part Select!!!
Thank you so much...
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- wondell from Winnemucca, NV
- Parts Used:
- 316233903
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Oven would not get up or stay up to selected temperature
Pull stove out to get behind it,unplug temperature probe plug. Remove temp probe from oven by removing the screw holding it in place on back of oven. Cut plug off temp probe unit leaving as much lead wire as possible on plug end. Strip wires on new probe and end of plug wires(one quarter inch). Then I used two small butt connectors to join the stripped wires,one for each pair of wires. Two small wire 'nuts' may also be used as the connections are outside the oven and not exposed to the heat of the oven while it is in operation. Hope this helps the inexperienced 'do it yourselfers'--:)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Terri from Findlay, OH
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The sliding drawer at the bottom of my stove would not stay in position.
I pul;led out the drawer and inserted the front glide in about 2 seconds and slid the drawer back in! Presto--fixed!
Was this instruction helpful to you?
Thank you for voting!
Drawer glide broken on electric range
Found correct parts on Partselect.com, watched the instructional video, ordered the parts and installed them when they arrived. Very simple, very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- robert from kettering, OH
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken glide
snapped new glide in place.
Was this instruction helpful to you?
Thank you for voting!
Replacing broken parts
Wow! That was simple! I did not even have to run all over town looking for the parts. I just hopped on the web, checked out the online diagrams, ordered and the parts showed up in the mail within a few days. It could not have been easier. Parts Select is now in my bookmarks for future use.!
Thanks guys
Thanks guys
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Aaron from Miamisburg, OH
- Parts Used:
- 3051163
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Best deal on the internet for a factory grate.
Ge wanted over a hundred dollars for the same part you charged only $80. Thanks. I'll be buying again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Petersburg, VA
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Drawer Guides Broken
New ones just snapped into place it takes less than a minute
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tracy from Frankfort, KY
- Parts Used:
- 3051163
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Draw would fall into the floor when opened
I watched the video before ordering the part. When it arrived, I knew exactly what to do. No tools were needed. It took me 2 tries to get the drawer aligned properly but the whole repair took about a minute. The video was invaluable!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mike from Everett, WA
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
I had a broken front drawer glide on my range.
Easy repair, I used a screw driver to pry out the broken part and no tools were required to put in the new part.
Was this instruction helpful to you?
Thank you for voting!