Models > JDS9860BDB21 > Instructions

JDS9860BDB21 Jenn-Air Range - Instructions

Jump to:

All Instructions for the JDS9860BDB21

Customer:: James from Cumberland, MD
Parts Used:: 12001656
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

oven not staying on. fault cod F-3 showing

Removed the back of the stove, un-pluged the sensor wires, removed the sensor from inside the oven. installed the new sensor, pluged in the wires, and replaced the back of the stove. A phillips screwdriver was the only tool needed.

Was this instruction helpful to you?

Customer:: Joe from Bronx, NY
Parts Used:: 74003645
Difficulty Level:: Really Easy
Total Repair Time:: 1- 2 hours
Tools:: Screw drivers

Broken inner glass

Easy just loosened screws took apart door, removed broken glass and installed new glass.It took longer to clean the stove! Lol!

Was this instruction helpful to you?

Customer:: Janette from Gainesville, FL
Parts Used:: WP8523793
Difficulty Level:: A Bit Difficult
Total Repair Time:: 1- 2 hours
Tools:: Pliers, Screw drivers, Wrench (Adjustable), Wrench set

burned out spark igniter

removing the screws holding the burner together was impossible. they snapped off and I had to drill them out. that took the most time. after that it was 100% easy hookup. clean up of the burner was done with a wire brush. good quality products. thanks.

Was this instruction helpful to you?

Customer:: Gerald from Melbourne, FL
Parts Used:: WP8523793
Difficulty Level:: Difficult
Total Repair Time:: More than 2 hours
Tools:: Screw drivers, Wrench set

Rusty screws

I had to use a dremel to grind the heads off the rusted in screws that hold the burners to the stove top then drill out the screws and use larger sheet metal screws to reassemble. Don't lift the stove top much with the burners attached or you'll bend the gas lines. Two screws inside the top oven hold the top down. Without the rusted screws it would be an easy job.

Was this instruction helpful to you?

Customer:: John from Dacula, GA
Parts Used:: 12001656
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Fan runs continually ,door locked,error code f2,f3,f7

Turned off breaker,opened door with bent coat hanger by sliding right to left the coat hanger to open the door, remover 2 screws holding in the sensor in upper left corner of the oven. Remove the sensor (gently) with the wire connection from back of oven pulling sensor out a out 8 inches . Disconnect plug. Install new sensor with matched harness /.connection, installed 2 screws ,turned on breaker.

Was this instruction helpful to you?

Customer:: Harry from Bedford, VA
Parts Used:: WP71002111
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Filter element missing screen material from age and cleaning

Lifter grill and replaced filter. It fit perfectly.

Was this instruction helpful to you?

Customer:: Janine from Hatfield, PA
Parts Used:: WP7801P173-60
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Missing Oven Rack

I think the installation instructions are fairly self explanatory. This is the second item I've ordered from Parts Select and I'm thrilled with their service. The items are always less expensive than other sites and they deliver what they promise. I would highly recommend them.

Was this instruction helpful to you?

Customer:: Christine from Pembroke, VA
Parts Used:: WP71002111
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Wanted to replace old grease filter

Removed old filter, dropped in new filter. A breeze! What was best of all, is that Parts Select shipped the filter immediately and it arrived within just a day or so! Well done!

Was this instruction helpful to you?

Customer:: Robert from Warroad, MN
Parts Used:: WP71002111
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Filter was old and discolored.

The new replacement grease filter came without damage and it was a simple task of removing the old and setting the new in it's place. No tools were required.

Was this instruction helpful to you?

Customer:: Betty from Hamburg, PA
Parts Used:: WPW10162384
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

replaced gasket around inside door

It was easy because the clips were already on the new door gasket. Just had to remove old door gasket and replace it with the new one. Very simple job.

Was this instruction helpful to you?

Customer:: Eliane from Potomac Falls, VA
Parts Used:: WP71002111
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

very old grease filter.

Very easy to replace the filter, nothing to it, take out the old filter and put in the new filter.

Was this instruction helpful to you?

Customer:: MaryAnn from Scituate, MA
Parts Used:: WP71002111
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Simply replace the grease filter

Thanks for carrying this part for my old stove. And thanks for the great service.

Was this instruction helpful to you?

Customer:: Donald from Newport News, VA
Parts Used:: WPW10162384
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

worn gasket

Removed old gasket and replaced with new gasket'

Was this instruction helpful to you?

Customer:: Clinton from Lander, WY
Parts Used:: WPW10310274
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Oven wouldn't heat

Remove the screw in each end of the element, remove the old element, install the new one and put screws back in.

Was this instruction helpful to you?

Customer:: Nancy from laveen, AZ
Parts Used:: WP71002111
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

needed to replace the grease filter

I lifted the grill off; took the old grease filter out and threw it away; placed the new filter in the well; put the grill back on. Wallah!!! just like new.

Was this instruction helpful to you?

All Instructions for the JDS9860BDB21