CG9617W439R Hardwick Range - Instructions

Got the new one and put it on

After ordering 3 or 4 different knobs for replacement, I found the one I needed. I did not have the oven model number at first...now everything is working fine. No tools, just push the knob into place. Thanks!

Inserting two stove valve knobs took 10 seconds! No tools necessary.

ordered new broiler pan

Removed what was left of the original clips. Pressed in the new clips and snapped in the themostat blub

I pulled the old knob off and popped the new one on! It was easy as pie!
The shipping was amazingly fast; I ordered the part on Easter Sunday and it was on my doorstep on Tuesday! Great service!

I pulled the knobs off and put the news one on. It couldn't have been easier. From my order to the fast shipping and helpful staff, I was completely happy.

PartSelect will be my first stop for all of my appliance repairs.

Thank you

Not much of a repair, just put the new one on. What I would like to share with you is the great ease of using Part Select Website. A stove knob you say? Well it seems like an easy part, but actually there a hundreds or more to select from. I could not find the model number on my stove. So I started looking through the site and it gave me options to choose from to narrow down the search. Being able to enlarge the part was extemely helpful, between 4 parts, I finally found the one that fit my stove. Might seem like not very much to you, but I was so happy that I finally found the part, it is the right part, and I don't have to mess with that stove thermometer anymore! The process was very easy, delivery was fast and I am one happy customer. Thanks Part Select! Debbie Watson

Matched up knob. 3D picture helps bunches

snaped them into oven cavity attached temp bulb job complete

Made sure the knob was in the Off position.
Removed the old knob by gently pulling it off.
Lined up the knob and pushed it on.

I just pop on the new knob. It was easy. And I got fast service order my knob and it got here in 3 days. I am very happy with your part and service. Thanks Donna Eden

Slid oven out from counters. On each side there are 3 screws on the front and three screws on the back holding the side piece on. Once off, the spring was very easy to get at and replace. I had only one broken, but replaced both anyways. I think it took longer to clean the sides of the oven that haven't been touched in years than to replace the springs. This job was very simple and easy.

Range is a 1967 model Maytag. First I removed drawer under oven, unplugged the range and pulled it out from the wall. Removed oven door by positioning it in the partly-open detent position, then pulled up to remove the door. Next I removed 7 screws per side panel: 3 in front and 3 in back, and one on top under cooktop, which retains the cooktop hold-down clip. With side panels removed, I noted the oven door spring position on the intact left side, then replaced the right-side spring first using the same spring adjustment positions. As I replaced the spring, I applied lithium grease to the spring hook pivot points as well as the spring coils where they rub against the interior wall. I repeated the process on the left side. I reassembled the side panels, oiled the door hinges and reinstalled the oven door. Reinstalled range and bottom drawer. The oven door operates like new, and the new springs are totally quiet — good for another 47 years!

Pushed on new knob. I was concerned temp markings would not be accurate so I purchased an oven thermometer. The markings were accurate to actual oven temp at 350 degrees so I am very happy with the replacement part. Thank You.