CEC3M6WTAA Gibson Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Sue from Lampasas, TX
- Parts Used:
- 5304409888
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Control will not work - only clock blinks
Took 3 panels off to get to the electric block. Replaced electrical block and put it back together. Still no change.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharon from Foley, AL
- Parts Used:
- 5304524341, 316538904
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken globe in oven and burnt out light bulb
Easy as 1-2-3
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- kathy from Eatonville, WA
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
change baking element
unscrew disconnect wires put new one on make sure you turn off power
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tonya from Buford, GA
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Bake element cracked
I followed instructions on the partselect website. I've never fixed any appliance before, but the directions were very simple and the oven was running again in less than ten minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrew from Bettendorf, IA
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
oven would not heat above 200
used the pliers to remove the screws, gently pulled back the element exposed the wires gently pulled the clamps of the element, removed the element. put the clamps back on the new element, put the element back in the holes and put the screws back in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ernest from Pocatello, ID
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Bottom oven Bake Element not Heating
Ordered the element from partselect. got the part fast. 2 days. removed the old element 2 screw and 2 wires.installed new one in reverse order. total of 10 minutes and oven is working like new. thanks partselect
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- timothy from tulsa, OK
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
element burnt out
unscrew 2 bolts and plug in 2 wires shipped and received in 1 day during christmas was suprised
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Columbia, MD
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Oven not heating properly
Replaced the baking element by removing two small sheet metal screws and unfastening the two medal clip/leads. Replaced the heating element, reconnected the leads, and refastened the screws. Took not much more then 5 to 10 minutes and the oven now heats perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Dayton, TN
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
oven element burned out
Plugged in new element
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Wallace from Fredericksburg, TX
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
The bake element had burned through at a point near the right connect point.
I removed the old part, went on your website and found the proper replacement part ordered it and received it the next day. Two screws and the new part was in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Randolph from Merced, CA
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Oven element burned out
Removed oven racks; removed the two hex head screws holding the element in place; disconnected the two wires that attach the element to the range. Attached the two wires to the new element; replaced the two hex head screws; replaced the oven racks; tested the element. The whole process took about 10 minutes!! And it's something I haven't done before!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bonnie from Saint Louis, MO
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Oven would take 45 min to heat to 425
The repair worked GREAT! It took less than 10 minutes and now the oven heats to 400+ in 5 minutes...the element came via regular shipping in 3 days. We were ready to buy a new slide in unit for 1000.00, now we have a 23 year old oven that works better than when it was new!! All for around 30 dollars. THANK YOU!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- KENNETH from SALMON, ID
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
No Heat
Remove defective element and replace with new heating element, bench checked servicable.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ronald from West Bend, WI
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
replace oven coil
unscrewed 2 screwes. very easy!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nancy from Lugoff, SC
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Oven element caught fire split in two
I am 75 year old female and this was a really easy job. Removed screws from rear of oven. Pulled towards me. Removed wire connections and connected to new part and replaced screws. You will notice an odor when you turn oven on. It will disappear in a few minutes. Don'T FORGET 2 TURN POWER OFF BEFORE BEGINNING
Was this instruction helpful to you?
Thank you for voting!