CEC1M2WSAB Gibson Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Kevin from Gorham, ME
- Parts Used:
- 5303051519, 5303935058
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Socket set
Stove Top burner didn't work/oven element burnt out
For the burner, I followed the simple instructions that came with the new burner(there is a video as well on this website). Cut the wire, stripped the ends off. The cereamic wire nuts were very easy to put on. That was pretty much it for the burner. Replacing the oven element was even easier. Two small screws, pull the element out about 3 inches, unhooked the two contact points and put the new one in. Voila, stove and top burner work like they used to. On a side note, the shipping was extremely fast. Ordered my parts on a Wed and they were at my doorstep on Thurs. NY to ME in 24hrs.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrew from Bettendorf, IA
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
oven would not heat above 200
used the pliers to remove the screws, gently pulled back the element exposed the wires gently pulled the clamps of the element, removed the element. put the clamps back on the new element, put the element back in the holes and put the screws back in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Orlando from Oklahoma, OK
- Parts Used:
- 316442300, 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
The surface and the bake element went out
By removing the back of the oven and unpluging the elementsand removing the ole and replacing it with the new one. It was simple
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- raymond from Wilbur, WA
- Parts Used:
- 316442300, 5303935058, 316048413
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
burner not comming on
unpluged stove pulled offback of stove behind buner controles took knob off burner switch took off two screws switchout put new switch in then took wires one at a time off and put on new switch put backon pluged in it worked
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ernest from Pocatello, ID
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Bottom oven Bake Element not Heating
Ordered the element from partselect. got the part fast. 2 days. removed the old element 2 screw and 2 wires.installed new one in reverse order. total of 10 minutes and oven is working like new. thanks partselect
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Vicki from Strong, ME
- Parts Used:
- 316442300
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Surface Element burnt out
Lift stove top cover up and support cover so it will not fall down unplug element put new one in close cover and turn burning on and watch the burner get red hot. simple job why call a repair man in. Vicki
Was this instruction helpful to you?
Thank you for voting!
Couldn't find drip pans that fit
I went to all of the do-it yourself stores and spent a bunch of money on aftermarket drip pans only to find out that none of them fit. I came up on your website and also called customer service. The found the right part and mailed it too me. They fit perfectly. No more burnt and rusty drip pans. I know where to go for parts now.
Was this instruction helpful to you?
Thank you for voting!
Replace ill-fitting drip pans
After two failed attempts to get the 'correct' drip pans for my range from two other supply outlets, Part Select had the proper drip pans for this model. They fit perfectly! Simple installation and threw away those cheap, poorly fitting replacement pans I've put up with for three years! Thanks Part Select for having the correct parts!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jaree from East Helena, MT
- Parts Used:
- 5303051519
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Bottom element burnt out
My husband removed the broken element within a few minutes & was able to install the new part in the same amount of time. Even though this was the recommended part for my oven it was slightly larger than the previous element, but all the important parts fit fine it's just a little bit longer (back to front) than the other. Oven pre-heats 3 times faster than before & cooks evenly again, very satisfied with it!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nancy from Lugoff, SC
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Oven element caught fire split in two
I am 75 year old female and this was a really easy job. Removed screws from rear of oven. Pulled towards me. Removed wire connections and connected to new part and replaced screws. You will notice an odor when you turn oven on. It will disappear in a few minutes. Don'T FORGET 2 TURN POWER OFF BEFORE BEGINNING
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Midway Park, NC
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Pliers
Bake Element Burned Out
The wire connectors were burn too, that may have caused the Element to burn-up on the end. The Broiler Element wire was getting bad too, so I replaced the old connector. Everything is working fine,I'm glad you guys were there.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- larry from lewes, DE
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
heat element burned out
i took two screws out and pulled the element out unplugged the wires put the wires on new one and put it back in place and screwed it in done less than 15 min. ordered part on line Sunday and had it by that Tuesday. very fast del.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alice from Hialeah, FL
- Parts Used:
- 5303051519
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Rotted
Husband replaced quickly no problems. This was the first time I have ever received a order so quick...(awesome service)
Was this instruction helpful to you?
Thank you for voting!