Models > JGBS60GEK2SA > Instructions

JGBS60GEK2SA General Electric Range - Instructions

Jump to:

All Instructions for the JGBS60GEK2SA
46 - 60 of 60
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Jenny from Muskego, WI
Parts Used:
WB35X29720
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Replace oven gasket
I used the pliers to remove the old pins, and popped then new pins in place...super simple!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mary from Redondo Beach, CA
Parts Used:
WB35X37973
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Wrench set
My oven bottom got rusty
I removed two bolts at the rear of the oven bottom. I pulled the old oven bottom out, and put the new oven bottom in. I put the two bolts back in and voila it looks like a new oven. Done in less than 15 minutes.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeff from League City, TX
Parts Used:
WB34K10010, WB34K10009
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Drip Trays lost finish due to use
Removed grates, lifted old drip pan, cleaned well and put new drip pans in. Simple and looks SO MUCH better!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robbin from Somerville, NJ
Parts Used:
WB34K10010, WB34K10009
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
needed new burners, gas tops and grills for hotpoint range
Customer service was above excellent! Parts delivered quickly!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Joan from Brooksville, FL
Parts Used:
WB34K10010, WB34K10009
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Pans were old and looked it!
The repair was just to exchange however, I am still shocked with the delivery. I ordered one day and they were delivered one day later. I was amazed.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Greg from Ft. Washington, PA
Parts Used:
WB02K10254
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
needed to unstall "anti tilt" bracket on back of electric range to be code compliant for property..
Turned off circuit breaker, Then pulled out range, straight out and away from wall and cabinets. Layed braket on flooring and moved stove back in to make certain it aligned with range rear stands. Moved range back out, marked holes in braket, screwed in screws to anchor bracket. Pushed range back into placed against wall. Tried to |"tilt" range by pulling down on door after opened - range was held in place sre
Was this instruction helpful to you?
Thank you for voting!
Customer:
Alice from Valatie, NY
Parts Used:
WB35X29720
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers
piece out of the oven gasket. Old and brittle.
Remover the old gasket and replaced it with the new. The small prongs I removed with pliers. Need to make sure that the new gasket isn't twisted when you put it on.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Joan from Watervliet, NY
Parts Used:
WB35X37973
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Forgot to remove the heat shield from the old part.
Husband actually did the repair, It went really well except he forgot to remove the heat shield from the old part to attach to the new bottom. (His mistake!)
Was this instruction helpful to you?
Thank you for voting!
Customer:
Willie from Selma, AL
Parts Used:
WB35X29720
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers
The oven door gasket was worn and didn't provide a good seal.
I use needle nose pliers to remove the old gasket tabs and clean the area with a scouring pad. Then I just lined the gasket up with the holes on the door and pushed the holding tab into the holds.Very easy and simple job.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the JGBS60GEK2SA
46 - 60 of 60