JSS06*03 General Electric Range - Instructions

I noticed two screws held the heating element in place. I removed the screws. Pulled the heating element out a few inches. Removed the two additional screws which held the two wires on.

To install the new element, I used the two new screws that came with the element to attach the wires to the element. Insert the element into position and attached the element to the rear wall with the two screws which were first removed.

turned off the electric at the breaker box.
removed the door, and racks. unscrewed two bolts, pulled out and unscrewed the leads. reattached the leads, and pushed in and reattached the element.
put the racks and door back on. turned on the electric and then tested the oven. easy!!

My husband removed the screws holding the element, disconnected the wires from the old element. He then reattached the wires to the new element, putting it back into place, tightened the screws, and we were cooking again. The shipping service was GREAT! I ordered the part on-line and it arrived next day! Thanks!

I removed the original element with socket set (two hex nuts). I removed the element and face plate, reversing the steps when installing the new element. It was simple.

I am a CPA and not real handy at all. But I was able to remove the old element and install the new element in less then 15 minutes. It burned out on Saturday, I ordered new one FED-ex to speed up- received new one, on Tuesday. Very quick, and this was last week, the week prior to Thanksgiving- so my wife really needed our oven. Perfect fit. And I am not related to this company in any way, nor was I paid anything to say this, just happy this worked- or we'd be spending a lot more money.

Remove two screws that secure the plate to the oven wall. Pull element out about 6 inches, then remove two screws that attach the element to power lines. Reverse for installation. Very easy.

Parts arrived quickly and install was easy as removing two screws and removing the broken burner. Installed the new and I was done!

The old part was easily removed with a nut driver, and the new element went right in with a nut driver and screwdriver.

Replaced old bake element with new one. 4 small screws/nuts. From order to fix was 3 days. My wife was impressed.

Went on line to find the part number and ordered the part. It came in the mail two days later and I installed in about five minutes.

Very easy to replace. Oven works like new again. If you have even the most basic visual and mechanical ability, you will be fine to do this on your own. Total repair time for me was less than 5 minutes. The part was an exact fit!

Took the old one out, measured it, ordered the appropriate size, intalled the new one.

I was able to slide the stove out from the wall, so it was easier to remove the back cover and disconnect the wiring in back rather than trying to reach into the oven. Then all I had to do was put in the new coil, reconnect the wires and slide the stove back into place.

It was quite easy-hooked up the wires replaced screws to hold it in place-finished!

Unplugged oven. Removed the two screws from inside the oven that secured element to the back. I then removed the protective cover for the plug from behind the oven-three screws. Disconnected the element from the electrical wires, removed and replaced the element. And reassembled the cover and all the screws in reverse order. Plugged it in. Presto, 5 mins and works great.