JGB3000ER2WW General Electric Range - Parts

This is a replacement cooktop mounting screw, used to secure the burner. If you are missing that screw on your range, this is the part to replace it. This screw is about a half an inch in length and i...

Screws not included.

The igniter does not come with wire nuts. *** Please NOTE: The igniter connector may need to be cut off and wires spliced to the range wiring with the porcelain wire nuts.

This bottom oven and deflector assembly is a durable metal panel designed to fit beneath the oven floor, protecting the bake element from spills while promoting even heat distribution for consistent c...

This oven temperature sensor helps maintain accurate heat by measuring the internal temperature and sending signals to the control board. If your oven is not heating properly or cooking unevenly, this...

Switching your GE stove from natural gas to propane? This orifice spud helps make that change safely and smoothly—especially for the right rear burner. It’s built to fit select models and helps your s...

Please note: With this control the wiring could be different from the original. It will possibly need to be installed by an appliance repair person.

This white outer oven door glass panel fits 30-inch free-standing ranges and provides a clear view into the oven while helping retain heat. It’s a direct replacement for damaged or worn panels. Use gl...

This economic nut is a manufacturer-approved replacement part for your oven range. The nut can become worn down or stripped over time and need replacing. Make sure to disconnect power to the unit and ...