JBP22*F2 General Electric Range - Instructions

First of all I did this repair because the wire to the burner shorted out. I did the wire portion first - only then did I know I needed the switch kit. (The burner was operating while my old swithch was OFF). The first (wire replacement) repair took about 10 minutes - I followed the guidance on this web-site. The second repair (The switch) took about 20 minutes. The switch ws not the same as the original. Just be careful to mark each wire as you remove them from the old switch's posts. The posts on the switch are marked and you need to place them on the like-marked corresponding posts on the new switch. All is well, my burner is operational.

Your "virtual repairman" was fantastic. I would have purchased the wrong part without trhe diagnostic service. It said that 53% of the time the infinite switch was the problem. In my case it was 100%. Why I put up with this problem for 6 years I will never know.

Repair job was easy but longer than the 15 minutes that it said it would take.

Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. Then I replaced it with the new element that took only two days to arrive and that was without paying extra express shipping fees. It couldn't have been easier. I didn't even wait for my husband to come home and install it. I had an oven-baked meal ready when he got home. I was very satisfied.

My daughter and I turned off the breaker to the range and removed the old element and replaced it with the new one. My husband came home and took over after we had done almost everything ourselves!!

It only took 15 minutes and a nut driver to replace.The part was $22,well worth keeping my oven going for a few more yaers

DISCONNECT POWER !!!! Removed 2 screws to get element loose from rear wall of oven and 2 srews to remove wires. Reverse for installation. The replacement part fit perfectly and works just fine.

I was able to slide the stove out from the wall, so it was easier to remove the back cover and disconnect the wiring in back rather than trying to reach into the oven. Then all I had to do was put in the new coil, reconnect the wires and slide the stove back into place.

Unscrewed the plate and unplugged the old element and plugged the new one in, screwed the plate back on. Done.

CAUTION: Make sure stove is unplugged as there is still current with it off! Removed 2 screws to pull old element out & 2 screws on electrical wires. Put new element in & screwed all screws, very easy repair. A big THANK-YOU to PartSelect for getting the part to us so fast!!

Unscrewed the two screws that held it in place; disconnected the old; connected the new; replaced the screws. DONE.

Simple replacement. Price for replacement was excellent. Cheaper than any replacement I priced locally and arrived the day after I ordered.


Thanks!

Remove the 2 screws, pull out the backing element. remove the 2 screws and replace the element....pay attention to what wire go where.

Actually you are right, I removed the two screw pulled the element out , disconnected the two wires holding the old element and put the new one on. I spent more time finding out whether or not it would be safe to work on it, being on my own for the first time and always had someone do it for me. I was told as long as the oven was not on it was safe and so I went to work. I was also very impressed at the short time it took to get the part. Three days!!!!!!!!!!!!!!!!!!

The old part was easily removed with a nut driver, and the new element went right in with a nut driver and screwdriver.