GLEF396CSC Frigidaire Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- robert from kettering, OH
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken glide
snapped new glide in place.
Was this instruction helpful to you?
Thank you for voting!
Drawer glide broken on electric range
Found correct parts on Partselect.com, watched the instructional video, ordered the parts and installed them when they arrived. Very simple, very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- wade from cadillac, MI
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Broken drawer guide
Popped out the old ones with a screw driver. Pushed in the new ones. Whole process took less than three minutes, super easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Birt from Brookfield, OH
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Missing drawer glide
I attached the drawer glide clips to the stove and inserted the drawer, done in minutes. The video on your site actually made it very easy made it so there was no guessing.
Was this instruction helpful to you?
Thank you for voting!
Replacing broken parts
Wow! That was simple! I did not even have to run all over town looking for the parts. I just hopped on the web, checked out the online diagrams, ordered and the parts showed up in the mail within a few days. It could not have been easier. Parts Select is now in my bookmarks for future use.!
Thanks guys
Thanks guys
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Terri from Findlay, OH
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The sliding drawer at the bottom of my stove would not stay in position.
I pul;led out the drawer and inserted the front glide in about 2 seconds and slid the drawer back in! Presto--fixed!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- wondell from Winnemucca, NV
- Parts Used:
- 316233903
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Oven would not get up or stay up to selected temperature
Pull stove out to get behind it,unplug temperature probe plug. Remove temp probe from oven by removing the screw holding it in place on back of oven. Cut plug off temp probe unit leaving as much lead wire as possible on plug end. Strip wires on new probe and end of plug wires(one quarter inch). Then I used two small butt connectors to join the stripped wires,one for each pair of wires. Two small wire 'nuts' may also be used as the connections are outside the oven and not exposed to the heat of the oven while it is in operation. Hope this helps the inexperienced 'do it yourselfers'--:)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Greenwich, NY
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken drawer glide
Fed ex dropped the part off at 7 one night, had it repaired by 7:05. Popped the broken glide off, popped the new one in. Easier than easy. Took longer to empty the drawer and remove it than to do the repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Aaron from Miamisburg, OH
- Parts Used:
- 3051163
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Best deal on the internet for a factory grate.
Ge wanted over a hundred dollars for the same part you charged only $80. Thanks. I'll be buying again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Anchorage, AK
- Parts Used:
- 3051162
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken-Missing Front Drawer Glides
They snap right into place in the holes at the front of the stove and the drawer is then slid back onto the glides and works properly once again.
Was this instruction helpful to you?
Thank you for voting!
the drawer glides were borken
I removed the brokne ones and replaced them with the new ones.
I appreciated PartSelect giving a picture of the parts so i didn't have to search for the part number.
I appreciated PartSelect giving a picture of the parts so i didn't have to search for the part number.
Was this instruction helpful to you?
Thank you for voting!