Models > CG3120SPA > Instructions

CG3120SPA Crosley Range - Instructions

Jump to:

All Instructions for the CG3120SPA
16 - 30 of 32
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Rhoda P. from Secaucus, NJ
Parts Used:
WP3413F018-19, WP3401F075-19
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
I needed a broiler pan
I took the broiler pan out of the shipping container and put it in the oven.
4 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Randy from Lufkin, TX
Parts Used:
74004844
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
My glass on the oven was broken.
All I needed was a phillips screwdriver to
take two screws out of the top panel. Then the two side panels pop off. Notice there are three click
tabs on each side panel, and also that the top and
bottom of the left and right panels, must be
manipulated in a sliding action(front to rear
facing the oven door front.) A good deal of
hand force is need to accomplish this.
Clean the old glass out, put the new glass in,
carefully might I add, and reverse the above
process. Just a little mechanical inclination
will get you there. Good luck!
I almost forgot to add that this job goes a lot
easier if before all of this, you simply remove the
oven door from the oven, by opening the door
about ten inches to the point where it stands
open on its own, then grasping it firmly on both sides and pulling up, with a slight jerking action.
This breaks it loose so it can very very easily be removed, and replaced. Best of luck!
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
andrew from haverhill, MA
Parts Used:
74004844
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
class on oven door broke
really eassy all you needed was a phillips screw driver
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Tara from ALBANY, NY
Parts Used:
WP5504M003-19
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
The oven bottom was warped and could not be positioned properly in the oven.
Removing the old oven bottom was easy...as it was already outside of its slots. Installing the new one was pretty easy. I placed the oven bottom in the front slots first...then the rear slots...no tools necessary.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sandra M from DISTRICT HTS, MD
Parts Used:
WP7801P173-60
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Oven Racks were old
Replace the racks. No special instructions.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mary from WINCHESTER, MA
Parts Used:
WP7212P043-60
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
1960's oven door gasket fell apart, actual gasket not available any more
Chose rubber flexible gasket with metal tabs. cut to size. unscrewed metal bracket on inside oven edge on 3 sides, slipped metal tabs between oven and metal and screwed back in. Done! Not a perfect fit but pretty good - better than no gasket.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Anita from ELKTON, VA
Parts Used:
WP7212P043-60
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers
My oven door seal had dried rotted
I took pliers to get the old one off, and popped the new one back in its place, and it fit perfect.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mz from COLUMBIA, ME
Parts Used:
WP7212P043-60
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Old seal breaking off oven door. Oven not baking food well, wasting heat and fuel.
Used pliers to remove clips and old seal. Snap in new seal. DONE! Less than 5 mins.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Linda from BURBANK, CA
Parts Used:
WP7801P173-60
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Original rack had melted plastic on it.
Removed the original rack. Checked dimensions, installed the new rack.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Willi from Old Saybrook, CT
Parts Used:
WP7112P004-60
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Thermostat bulb was hanging loose
Removed what was left of the original clips. Pressed in the new clips and snapped in the themostat blub
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Roger from San Juan Capistrano, CA
Parts Used:
WP5504M003-19
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The floor panel of the oven was pocked and in bad shape
I found the panel on the innernet, ordered it and when it arrived I removed the old one and replaced it with the new one.
2 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Dwayne from Atlanta, GA
Parts Used:
WP7112P004-60
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
thermostat temprature bulb hanger clips
snaped them into oven cavity attached temp bulb job complete
1 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jennifer from Lynn, MA
Parts Used:
WP7212P043-60
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Rubber seal was broken
Broke the same day I installed it
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael P from Hickory Hills, IL
Parts Used:
WP7212P043-60
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Door seal was pulled out by grandson.
finished removing door seal, used pliers to remove old securing studs. positioned new seal and pushed securing studs into existing holes and was done.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Phillip from Twentynine Palms, CA
Parts Used:
WP7212P043-60
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
As easy as it could be
I have worked in maintenance field most of my adult life and all aspects and to change the oven door gasket was no challenge what so ever. It took longer to find my needle nose pliers to remove the old gasket clips and then re-install the new gasket. Maybe 10 minutes total
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the CG3120SPA
16 - 30 of 32