CE35111AAD Crosley Range - Instructions

Upon receiving the replacement part, I noted that the socket was held in place by simple expanding tabs. TURN OFF POWER TO THE OVEN. Using a right angle pick or similar tool, bend the tabs inward on the existing socket and remove. Disconnect the white, black and green wires. Note which tab is the green tab. Attach the wires to the new socket. Push the new socket into place, aligning the key bump on the socket with he slot in the oven wall opening. Install bulb and diffuser.

1. turned off the breaker delivering power to the oven. 2. removed the grates. 3. unscrewed the 2 screws holding the element in place and gently pulled the2 ends of the element from the rear of the oven. 4. disconnected the 2 power connections from the element being careful not to have them slip back into the insulation at the rear of the oven. 5 removed the element and connected the new element to the power sources - this was the most difficult task, with little wire extending from the back of the oven it required delicate handling and certainty that the connection was solid. 6. slid the 2 prongs of the element into the rear of the oven. 7. installed the 2 screws. 8. replaced the grates.

First we watched a video on how to repair it. Then just followed through with the instructions. The part was delivered to my house in just a couple days.

removed two screw and two wires from old element. Plugged in new element and mounted it back in less than 5 minutes time.

Disassembled upper unit with Phillips screwdriver. Removed 2 "plug connectors" from element switch. Replaced switch. Plugged both connectors back onto switch. Reassembled the upper portion of the range. Tested and OK

Disconnect the range from wall outlet. remove 2 screws in the back of the cabinet,remove switch plug. connect back range to outlet to check if it is the switch. make sure the light isn't on. then I order the switch online at PartSelect.com and it arrived in 2 days. When I installed the piece, the problem had been solved. I hope this information will be helpful for others.

Powered off circuit at breaker switch, removed oven door (slide-in), unscrewed two Phillips head screws holding old element, unplugged old element, plugged in new element, screwed in new element, replaced oven door and turned-on circuit. Total repair time: 8 minutes. Total time procrastinating repair: 1 week. Happy Wife: Priceless.

This is a no brainer. I am only doing this because you asked. Pull out the stove, tilt it back, remove broken leg, install new leg.

My used stove had been dropped by the previous owner. While I could live with the minor scratches on one side the wooden shims holding up one corner were annoying. A new leveling leg was less than $2. I used a pair of needle nose pliers to straighten the mounting hole and screwed the new leg in. This used stove was originally $2000 but I bought it for $999. the new leg plus shipping was about $10. What a deal.

I have worked in maintenance field most of my adult life and all aspects and to change the oven door gasket was no challenge what so ever. It took longer to find my needle nose pliers to remove the old gasket clips and then re-install the new gasket. Maybe 10 minutes total

I first pulled out stove, then disconned the power supply. Then removed rear panel which exposed connections to the bake element which was shorted out against one side of the rear panel. Replaced the bake element, then the rear panel followed by pugging in the stove and pushing it back into place then opened the oven door and tested the element to see that it was working properly. Thank you Partselect for your fast service on getting the part that I needed quicky and at a fair price.

Unplugged the stove removed back cover plate unpluggeg two wires removed racks from oven removed two screws that hold bake element in place and reversed process

Replaced element. Wires to short to replace element from front. Removed back panel and acessed connections to new element. Was easy even tho had to remove back panel because of short wires.

I am a 60 year old women and I was so amazed that this was so easy, Except for whom ever put in striped screw before, got that out with a pliers. Thanks for your video online. Beautiful.

After we got the part in the mail my husband put it on and shortened the wires and put new plugs on the ends of the wires and we had to get a new plug put it on and it was fixed.