Models > CRG3150LBC > Instructions

CRG3150LBC Crosley Range - Instructions

Jump to:

All Instructions for the CRG3150LBC
106 - 120 of 127
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Diane from Natrona Heights, PA
Parts Used:
316239700
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
55 yr old wall oven had burnt out seal
Very easy--just had to drill new holes for the clips because the are already pre set in the rubber gasket
Was this instruction helpful to you?
Thank you for voting!
Customer:
Randall from Fernwood, ID
Parts Used:
GRLP3
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Convert NGas to LP
The Conversion Kit was throughall with extra fittings and good instructions. My problem was haveing to pay a lisence gas installer $65.00 an hour to do a safety & pressure test. Maybee future Conversion kits would include a cheap disposable pressure tester with hose, then it would be a complete done job by the owner.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Vernon from Moorehead, KY
Parts Used:
GRLP3
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Socket set
bought a used gas range i have propane it was natural gas
changed the orfices with a 10mm socket and driver handle used an adjustable wrench to tighten the orfice in the bottom of the oven approximately 45 minutes we were using the range
Was this instruction helpful to you?
Thank you for voting!
Customer:
steven from Daleville, AL
Parts Used:
316233903
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
No heat from bottom or top element,k stove top and clock all worked fine.
Timer was bad. Removed the four screws on the rear panel, and then the four screws holding the timer in place. I let the old one dangle by the wires until the new one was in place, then just switched the wires one at a time. There is one set that has a plastic connector, and you need a small flat screwdriver to depress the locking tab on the top of the connector to release it. Be sure and order a new face plate as the old one will not come off without tearing. Re-install rear cover and your done.
Was this instruction helpful to you?
Thank you for voting!
Customer:
KAREN from INDIANAPOLIS, IN
Parts Used:
5304506004
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
inside oven glass had cracked.
I got the ex husband to come over and take it apart and fix it, he said that it was a really easy repair to complete.
Was this instruction helpful to you?
Thank you for voting!
Customer:
BARBARA from NORTH PORT, FL
Parts Used:
316233903
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers
no heat in oven
replaced temp probe per your suggestion. No improvement! checked both heating elements with ohm meter. OK Next suggestion was replace circuit boards. Bought new range for less than cost of 2 oven/range control boards.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Julie from Doyle, CA
Parts Used:
5304518661
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Clock/Oven program didn't work.
Very easy, just pulled the oven out and unscrewd the back, took the old program out plugged the new one in and it works just fine.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from Hiawassee, GA
Parts Used:
316233903
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Socket set
wrong temp when baking.
removed back. discovered wrong connector on probe. Cut the connectors off and spliced with small butt connector. Took me longer to find the tools and connector than to do the repair. The wires are very small and require a very small butt connector. Tips by the sales rep and previous customer were helpful. Great service. Will try PartSelect for Cub Cadet and Yamaha OB parts. Thanks. John
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the CRG3150LBC
106 - 120 of 127