CC3531WUV Crosley Range - Instructions

first I removed the 2 screws, I then pulled the element out., accidently lost one of the wire in the insulation and had to take the back panel off which was 8 screws. Probably doubled my time. I received my part in 4 days thanks to good service and FedX It arrived the day before Thanksgiving. Just in time, Thank You All.

used the supplied parts...very easy. The parts were exact replacements.

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

I unplugged the stove. Took out the burner and removed receptacle by pulling it out of the bracket and clipping the wires. One thing you want to make sure is that when you clip the wires from the receptacle you're replacing you leave enough wire so that you can connect them to the wires on the new receptacle when it is in place on the stove. I had just enough but would have liked more. The bracket I received didn't match the one on the stove so I used the one on the stove since the receptacle itself was the same as the one I was replacing.

Called repairman, he never called back for a week. Gave up and found your website, ordered the part. You said it would take 3-5 business days. You lied, it was there the next day. Taking old element out starts with shutting off the juice. Remove trays, pans, etc. Unscrew two screws, pull out elements ends, unclip from wires, reverse the process with new one. You need a light to do this.

First I disconnect the breaker. I removed the defected receptacle and cut the wires. I connected the new receptacle with parts with the new part. Turned the breaker back on and everthing worked fine.

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires reverse the order to install the socet was easy but after i was done discovered that the base of the old bulb was stuck in the socet keeped it for future use

the new elements were super easy to replace. the old ones just pulled out and the new ones easily pushed in. the top one was a little more difficult only because it had brackets that had to be slid of and then slid onto the new one.

Broken part was already removed, so I used the screw from the broken support and installed the new support. Very simple, easy, and painless.

removed drawer from track replaced supports on track and one on the drawer.

turned off power removed old element .connected new element reinstalled works fine .part fit was correct part first time something rare in this day and age.

I watched the video provided by Part Select before I ordered the part. I removed the old element by taking out two screws and unplugging it from the wires. I put the new element in place, connected the wire to the right side and then opened up the back of the range to connect the left side. The repair was easy, but the video did not show that you had to connect the left side from the rear of the appliance. It was easy to figure out. The appliance works like a charm...no like an oven.

We repalced the heating element n no time. Easy to do and the price couldn't be beat!

I removed the element from the back of the oven.Then i removed the wires from the bad element. I then attached the wires to the new element,and screwed it into place.

Watched the video provided and followed the instructions. I couldn't believe how simple it was to fix the problem! I ordered the part Sunday evening and it was sitting in front of my door Tuesday afternoon. Talk about service! I couldn't be more pleased with the convience of fixing my problem right from my own home. Thank You!