Models > ART6511E > Instructions

ART6511E (P1143623N E) Amana Range - Instructions

Jump to:

All Instructions for the ART6511E

Customer:: martin from portland, OR
Parts Used:: WP74011278
Difficulty Level:: A Bit Difficult
Total Repair Time:: 15 - 30 mins
Tools:: Pliers, Screw drivers

oven light replacement

bought used, oven light was damaged from previous repair attempt, without installation instructions removing the fixture was tricky, had to bend the housing tabs inward w/screwdriver to release fixture (more damage). once out the new fixture went in place quite easily, wires simply hook up, re install back panel, re-connect power, Have a nice Day!

Was this instruction helpful to you?

Customer:: Hugh from Greenville, SC
Parts Used:: WPY0061732
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver

Replace broiler element

Unscrew and remove old element, install new element.

Was this instruction helpful to you?

Customer:: DAVID from FRANCISCO, IN
Parts Used:: R0706011, R0706010
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Broken Hinges On Oven Door.

I had already removed the old hinges by removing the screws/bolts and removing the broken hinges from the back side through the drawer below the oven that I had already removed. Took the new hinges and screwed the two metal screws into the top hole on the new hinges after placing hinge in vise, one screw on each then removed them and placed them to the side. Determined the right tap from my tap set, and then tapped the bottom two holes on the new hinges, one on each. Placed the bolts that came with the new hinges into the holes I had just tapped, screw them in, then I removed them and placed to the side. Took hinges and bolts / screws to the oven, inserted hinges in through the drawer that I had removed up to each side where hinges would come back out to the front of the oven. Placed screws / bolts one at a time through oven door frame into the hinge on the back side, and then threaded them into the hinges and tightened. Replaced oven door onto new hinges and checked for correct operation. Door works like new.

Was this instruction helpful to you?

Customer:: Hau from Burke, VA
Parts Used:: 31750717
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver

Stove Range Drawer Difficult to Open and Close

Insert one end of the railing into the slot in the back of the stove. Align the front end of the railing with the hole at the front of the stove. Align the roller with the hole. Secure the front end of the railing, roller ,and hole with the shoulder bolt using a 10mm wrench. Tighten just enough but don't over tighten.

Was this instruction helpful to you?

Customer:: Kathleen from Weston, WI
Parts Used:: WP77001094
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Pliers

oven coil burned out

by myself

Was this instruction helpful to you?

Customer:: Robin from Vanderbilt, PA
Parts Used:: WPW10245259
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Socket set

I had a power serge and it burned the Plug at the termial block and melted a few wire.

After we got the part in the mail my husband put it on and shortened the wires and put new plugs on the ends of the wires and we had to get a new plug put it on and it was fixed.

Was this instruction helpful to you?

Customer:: Wesley from Norman, OK
Parts Used:: WPY0314907
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

Oven not heating, F3 trouble code.

Removed back panel, unplugged sensor, removed sensor from inside oven (2 screws), replaced with new part.

Was this instruction helpful to you?

Customer:: david from cleveland, TX
Parts Used:: W10823699
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Burner Would,Nt Heat Up.

Removed top of stove replaced heating element ,piece of cake.

Was this instruction helpful to you?

All Instructions for the ART6511E