Models > RD80704

RD80704 Ridgid Pressure Washer

Jump to:

Find Part by Name

Diagrams for RD80704

Viewing 2 of 2

Page A

Page B

Most Popular Parts for RD80704

Viewing 12 of 110

Thermal Relief Valve

This thermal release valve is for pressure washers. Thermal release valve attaches to the pump and releases the water and high pressure inside the pump if the water temperature exceeds normal oper...

Trigger Handle Assembly

This is a genuine OEM sourced replacement part designed for use with Ridgid pressure washers. It is the essential part of the unit allowing to direct and control the spray. Please note the wand is sol...

Spray Wand Extension

This is an OEM part sourced from the original manufacturer for use with pressure washers. This stainless steel spray wand screws into the trigger handle assembly, giving a 21" reach. One spray wand is included.

Chemical Siphon Tube

$6.15

It is a genuine replacement part that is supplied by original equipment manufacturer for use with Homelite, Ridgid and Ryobi pressure washers. This siphon tube is used to deliver the chemical solution...

Order within the next 5 hrs and your part ships today!

Grommet

$2.99

This authentic item is supplied directly from the original equipment manufacturer for use with pressure washers and generators. The wear pad is made of hard rubber and attaches to the foot bracket wit...

Dual Power Soap Nozzle

This is an authentic OEM replacement part guaranteed to fit the pressure washers listed below. This dual power soap nozzle can be adjusted for either short or long range detergent application. If no d...

Seal

This seal is designed for pressure washers made by Ridgid, Homelite and Ryobi. It is made of metal and fits onto the idle down assembly. A wrench may be required while replacing this part. Please keep...

Quick Disconnect (Female 3/8 In)

This is a genuine OEM sourced replacement part. The quick disconnect is intended to be used with pressure washers from Ridgid, Ryobi, and Homelite. The quick disconnect is used a the female portion of...

Filter (Injection Hose)

Lock Nut (1/4 In)

This genuine manufacturer sourced replacement part that is specially produced for use with Ryobi, Ridgid and Homelite equipment. A lock nut is a type of nut that resists loosening when properly thread...

Idle Down Assembly

This assembly uses a control wire inserted directly into the throttle arm to control engine's speed. If your engine doesn't idle down replacing this part should resolve the issue. Please make sure to ...

SIDE HANDLE ASSEMBLY

$2.99

This is a genuine Ridgid replacement part. Constructed of durable plastic with a metal screw, the handle gives the user added control of the device. This part has been designed to simply twist into th...

Questions and Answers

Ask our experts a question about this part and we'll get back to you as soon as possible!

1 question answered by our experts.

< Prev
1
Next >

Sort by:

Charles

July 4, 2023

when i turn on the gas it starts leaking gas

For model number RD80704

Hello Charles, thank you for the question. According to our research, the reason that the carburetor is leaking is because the float needle is not seating against the seat and is allowing too much fuel to bypass through the carburetor and it usually drains out through the air filter. We would recommend checking the carburetor assembly, part number FIX11851993, to fix the issue. We hope this helps!

Was this helpful?

Related Parts: