IBMS1455VW0 Whirlpool Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Lyn from Sonoma, CA
- Parts Used:
- W11373838
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Replaced broken glass cooking tray
I took the new try out of the box and placed it on the turntable and I was DONE! Took about 10 seconds. The delivery was speedy as promised. I will definitely order from this company again for replacement parts.Very good customer service and communication.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- nana from pembroke pines, FL
- Parts Used:
- WPW10120220
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Screw drivers
Breaker Tripped, Puff Of Smoke From Unit
Removed built in unit from cabinet and looked for faulted component spied burnt spot where filter went to ground on frame removed and matched part on manufacts web page. .
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ken R from Eagan, MN
- Parts Used:
- WPW10124269
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
LCD display lost some lighted bars that form the numbers
Removed microwave from wall (it is a built-in). Removed top of cover. Removed 4 screws that held the front panel. Pulled front panel out. Unclipped LED Display from holder. Unplugged the 2 flat cables. Removed old Display. Inserted new Display. Clipped Display in place. Plugged the 2 cables. Reinstalled front panel. Reinstalled cover. Plugged into outlet and tried it out. Viola! Reinstalled into wall.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Curtis from San Jose, CA
- Parts Used:
- W11223840
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
The shaft on the turntable drive coupler was longer than the original one that was broken..
All other measurements were similar and fit properly. The drive shaft of the coupler was TOO long by about 3/16". I had to cut it down to the size of the original OEM shaft using a fine cut hack saw. Seems to work perfectly now....
Was this instruction helpful to you?
Thank you for voting!