GH6177XPT1 Whirlpool Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- sharon from LAS VEGAS, NV
- Parts Used:
- 4393799
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
glass turn table cracked needed a new one
easy to replace, just the same as cleaning the turntable and placing back in the micorwave;
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrew from Carlsbad, CA
- Parts Used:
- W10450189
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Grill Broke
SO EASY... It just clipped right in...
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Smithtown, NY
- Parts Used:
- W11707984
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
machine was dead.
After removing the over-the-range unit (no small feat!) I had to figure out how to open the case (good puzzle!). Capacitor had already discharged, so it was very easy to reach in, pop the old fuse and install the new one! As per your advice, I found out I was a "28%-er"! Upon re-installation, the microwave "sprang to life"!! Thanks, "Part Select"!! I was already shopping around for a new machine! (Now if you could only tell me an easier way to re-mount this heavy beast over the stove!!!)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lillian from SAN JOSE, CA
- Parts Used:
- W10748097
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
my pan that browns the meat started to bubble and peal
I really did not have a repair on the microwave just a replacement of the browning pan
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Susan from LAFAYETTE, LA
- Parts Used:
- W10450189
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The original clips were broken on the vent
New vent came and fit perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BILL from SAINT JOHNS, FL
- Parts Used:
- W10450189
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
broken vent gripll
removed old one. new one snapped right in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Eldon from ORANGE, CA
- Parts Used:
- W10642989
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Turntable did not work
Ordered a new motor. Removed the outside trim of the oven-microwave combo. 2 screws at the bottom of the trim. Removed the screws that held the combination micro and oven unit in place. Removed the top and bottom black plastic grill of the microwave. 3 screws each. Pulled the entire unit out about 1 inch exposing the screws at each side of the microwave that hold it in place.
Snapped off the top control panel which exposed the wiring connecting the control panel.
Unplugged a couple of wire harness units to free the control panel.
Be sure to label the units to know which goes where during reassembly.
Remove the microwave unit from the housing and place it on its side.
Remove the metal plate that houses the motor. 4 screws hold the motor in place. Disconnect the 2 wires from the old motor and you are ready to install the new motor. Be sure to TURN OFF THE POWER to the unit at the breaker box and remove the turntable from inside the microwave.
Snapped off the top control panel which exposed the wiring connecting the control panel.
Unplugged a couple of wire harness units to free the control panel.
Be sure to label the units to know which goes where during reassembly.
Remove the microwave unit from the housing and place it on its side.
Remove the metal plate that houses the motor. 4 screws hold the motor in place. Disconnect the 2 wires from the old motor and you are ready to install the new motor. Be sure to TURN OFF THE POWER to the unit at the breaker box and remove the turntable from inside the microwave.
Was this instruction helpful to you?
Thank you for voting!
Very unusual. we had a brief fire inside the microwave which destroyed all the moving rotary parts.
First, we had to clean up all the interior surfaces, which was just cleaning. There was no internal damage. Then, just setting the center connector, rotary rollers and glass plate. Simple
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Linda from FT LAUDERDALE, FL
- Parts Used:
- W10450187
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Over range microwave vent grille fell off. No clips attached.
Ordered new grille in hopes it would have clips attached as none were on old grille. Kept my fingers crossed that new grille would just snap back on. It did. No tools required.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from CENTENNIAL, CO
- Parts Used:
- W10435116
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Drive coupling cracked would no longer rotate turntable plate
used screw driver to pry up old part. lifted right off. line up drive couple drive push on. repair took less than 1 minute to repair. works like new
Very Pleased with Parts Select replacement parts
Very Pleased with Parts Select replacement parts
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharyn N from CLEMMONS, NC
- Parts Used:
- W10450187
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Vent grille broke
Fit it into the frame and it popped right in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrew from JACKSONVILLE, FL
- Parts Used:
- W10450172
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken vent for microwave.
Exact piece arriven. All I had to do was line it up on the correct bottom guides press hard on the top and it snapped into place. Everything lined up.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from EXETER, NH
- Parts Used:
- W11252182
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
One of the wheels came off
Took out turntable and swapped out old one with a new bright and shiny
New one, ring that is. It was easy using the part from parts select
Thanks
Paul
New one, ring that is. It was easy using the part from parts select
Thanks
Paul
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Beau from Cary, NC
- Parts Used:
- W10450189
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
vent grille was damaged and would not stay on.
easy squeasy, lemon-peasy. Took all of 15 seconds. Opening the box took longer than installing the vent. It just snaps right in place.
Was this instruction helpful to you?
Thank you for voting!
The old coupling melted and the tray cracked in half.
It took me 15 minutes total - 5 minutes to clean the microwave, 1 minute to install three new parts, and 9 minutes to enjoy my celebratory glass of wine!
Was this instruction helpful to you?
Thank you for voting!