MH1170XSS0 Whirlpool Microwave - Instructions

My husband open the microwave and see the capacitor melted. He try to find the piece in store,but unfortunatly he didn't find any. I found the piece on the web and ordered it. My husband replaced the part easily. The microwave work very well.The microwave was to our friend. He did replace it by a new one. Now we have a new microwave with a fan.

Arrived in 24hours!!! Great.

Removed 2 screws on the top of the microwave and removed top/front piece of microwave. Slid out old filter (which didn't look dirty at all) and replaced it with the new one. Replaced top/front piece and 2 screws. It took less than 5 minutes.

unscrewed the screws and put the new vent in

1. Safely unplug the dryer. 2. Unconnect the vent hose. 3. Pull it out so you can have room to move around to work on it. I actually in a power chair so I put an old blanket on the floor and laid it face down to work on it. It was extremely dirty so I used a shop vac to clean off the back panel before starting. 4. I took off all the screws and cord cover with a nut driver, used the shop vac again to clean the entire inside. Properly a 1/2 to 1 inch of dust and lint was built up causing a dangerous fire situation for sure. Once clean, take a photos especially of where the electrical connection are. 5 Located and removed the two screws holding the element on, used a nut driver and long nose pliers to remove the heat sensor & electrical connections. 6. Dry fit the element before tightening screws to make sure placement is correct then match the holes replace the screws. 7. Using the photos put the heat sensor & electrial wires back on, you may need to use the pliers to push it on tight. Double check everything, clean back panel inside and out, match up holes replace screws, I actually checked my power cords screws for tightness then replaced cord cover. 8. Replace vent hose if needed or then reattach it and plug it up. You may need to check the dryer barrel by turning the drum around a few times. Should work perfect, you will smell the element a little but it should be ok. Remember clean your dryer inside and out every six months or so to prevent dryer fires.

Twas really easy considering that all I had to do was place the plate back in the microwave. Easy Peasey

Tray arrived in a short period of time and was a perfect match.

removed perimeter screws from the bottom side and the lower cover is hinged at the wall side. Motor is visible and easily removed with two screws. Take of the old one, install the new one, and reverse the procedure to put the bottom cover back in place. Will nee helper to hold one side of the bottom until couple of screws can be put in on the other side.

FOLLOWED EASY INSTRUCTIONS VIA THE WEB.Note: I am a widow...83 yrs of age. Thanks for making it easy!

The filter was just a maintenance issue. The vent grille, as described on the website already, is poorly constructed; the plastic where the screws attach to hold it on break easily. I ended up using something similar to the plastic of a credit card to make a repair to the side that had broken. I ended up not installing the new grille, I thought I would see how the repair I made held up first. I kept the grille as a spare when the old one finally breaks. CAUTION: When you clean the grille, take it off first! The two spots where it attaches are cheaply made and will break easily. Take out the two screws, clean the grille, and then put it back into place. DO NOT OVER TIGHTEN THE SCREWS! Tighten them just enough to hold it in place.