MH7130XEB0 Whirlpool Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Jeffrey from Long Beach, NY
- Parts Used:
- 4359540
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Face of door was cracked
First I removed the panel covering the fan exhaust area by removing the 4 screws on top of unit. Lifted off the old door and set new door in place. Replaced the panel by using the aforementioned 4 screws.
Definitely easy to do.
Definitely easy to do.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joshua from Hollywood, FL
- Parts Used:
- WP8205176
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The old grille had cracked in several places
You need a philips head screwdriver to remove the two screws at the top of the microwave, freeing the old snapped off clips. The new grille does come with the clips already installed, which I hadn't been sure of, since you can't buy the clips by themselves. Let me reassure you if you're wondering too. Snap the new grille in, tighten down with the screws from the top, and I was done. Took me seven minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Daniel from RIVERVIEW, FL
- Parts Used:
- WP8205176
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Microwave over 10 years old.
My microwave vent grill broke from age. Ordered the new vent, which came with clips. I installed it in about 10 minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from NINE MILE FLS, WA
- Parts Used:
- WP8205176
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The 20 year old original vent grille brittled and snapped at the clip lip.
The replacement took about five minutes and the only tool require was a Philips screwdriver. I just removed the old one and slipped in the new part. The replacement vent grille sent by PartSelect was a perfect fit.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Craig from Swansea, MA
- Parts Used:
- WPR9800384
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
One of the shelf plastic holder was broken
I was able to find the part on line and within a few days received the part and installed it with no problems thanks to the website drawing information.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Francis from Doylestown, PA
- Parts Used:
- WP8205489
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Outside of cabinet got hot & food inside of microwave did not get cooked
Replaced the diode (aka wire-vltge) in the HV circuit after removing cabinet cover using both the secure torx screw drvr & phillips head screw drvr. The hardest part of the job was finding the secure torx nut drvr tool on the internet & purchasing same.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- M. J. from Chester, NH
- Parts Used:
- WP8172138
- Difficulty Level:
- Really Easy
- Total Repair Time:
- More than 2 hours
I broke the dish in my microwave unit.
I simply went on line to Part Select, placed my order, made payment, and was astonished to see the package with a new dish sitting on my doorstep the next day.Great service.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lewis from Loveland, CO
- Parts Used:
- 4392027
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
motor would start by itself when door closed
remove 4 screws from top, front louvered panel snaps out. remove 1 screw from top of keypad, keypad pivot's forward and can be removed. There is a white mounting bracket inside left. Remove two screws, one top and one bottom, bracket lifts up and out. 3 sets wires are attached, mark them with masking tape, top, center, bottom and pull out plugs. They can only attach one way. Using a very small screw tip, lift plastic latch from switch, it rotates out and is removed from the pivot pin. reassemble in reverse order after switches are replaced
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cassandra from Cleveland, OH
- Parts Used:
- WP8172138
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
microwave plate broke
Just took the plate out the packaging & rinsed,dried and put in the oven. I was so happy I found it @partselect online& it came in the next day or two. Will definitely use them again. It was a fraction of the cost from local parts store.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- chap from edmond, OK
- Parts Used:
- WP8183507
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Approximately 5 seconds into heating something, the microwave went dead
It literally took me longer to unpackage the fuse than to install it. I removed the outer shell by unscrewing the five screws, lifted it off and set it aside. The old fuse was readily visible so I pulled it out and put the new one in its place. I set the shell back on and replaced the screws. I plugged it in and ran it for 30 seconds while still in the shop just to make sure that solved the problem and presto - it worked like a charm. A $20 part saved me from having to purchase a new microwave (sadly, I had to break the news to the wife).
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- miriam from brookline, MA
- Parts Used:
- WP8172138
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
cracked revolving cooking tray
OMG! I wish everything in life were so easy.....The cooking tray of our 15 year old microwave cracked and I swore it'd be impossible to find a replacement. That is until I discovered Partselect.com!!All I had to do was input the appliance brand and part I was looking for, and there is was. Thank you, Partselect.com!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Banning, CA
- Parts Used:
- WP8205176
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Vent Grille had broken and screw holes
Kept the screws from the old part. Simply slide the new grille in place and screw in the two holding screws!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- virginia from mattituck, NY
- Parts Used:
- WP8205176
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Grill vent screw holes broke
Went on very easy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BRIGIDA from GAINESVILLE, VA
- Parts Used:
- WP8172138
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Too Big Didn' Fix
I received my glass cooking tray so fast but when I try to put in the microwave did't fix was to big,I call you today to return and very nice lady help me and told me I need to call whirlpool and explain them and already order again thank so much for all your help you have very nice people in customer service. Thank you so much again. !!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thais from La Grange, TX
- Parts Used:
- 4392027
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
Motor quit working but light and timer still worked.
Since others reported similar problems and it was just the fuse we tried that first. That wasn't the problem so we ordered the Door Interlock Switch Kit. Shipping was very fast! Our microwave had 3 switches. My husband asked how to know which one to switch. I read that one person just did process of elimination. Luckily ours worked on the first change out! So happy to have stumbled across this site and not have to buy a whole new microwave.
Was this instruction helpful to you?
Thank you for voting!