Models > MC17F808KDT > Instructions

MC17F808KDT (AA-0000) Samsung Microwave - Instructions

Jump to:

All Instructions for the MC17F808KDT
16 - 26 of 26
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Michael from LAKE FOREST, CA
Parts Used:
DE64-02524C
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers
The piece that holds the door latch spring to the door frame snapped off
This part is basically the door to the microwave so every part on the original door has to be carefully removed and reassembled onto the new door frame.

Pry off the inner trim piece off with the putty knife so you can lift the door off the microwave and lay it on the floor to work on it. Start removing all the pieces attached to the door and lay them out in order so you'll remember how they go back on the new frame.

For the glass plate, I ran a metal putty knife between both sides of the glass and the old frame to loosen it enough to carefully slide it out of the old door. The stainless steel decorative facing on the old door is glued on so I used the putty knife again to push through the glue to get the facing off the old door.

Putting everything back on the new frame is pretty straightforward. You will need some type of adhesive to hold the decorative facing flush to the new frame.Not a quick job so take your time disassembling the old door so you don't break or damage anything..
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Marilou from Sylmar, CA
Parts Used:
DE74-20016A
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Microwave cooking tray cracked
We just order the tray and basically replaced it with the new one we ordered. It fits perfectly. Very happy with the purchase.
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Tasha from York, PA
Parts Used:
4713-001165
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Light under the microwave went out
To replace the light bulb was fast and easy. All I had to do was unscrew one screw and place the bulb in! Quick and easy, and simple!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Juel from White Bear Lake, MN
Parts Used:
4713-001165
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Bulb burned out
Replaced the bulb
Was this instruction helpful to you?
Thank you for voting!
Customer:
Steve from Hampshire, IL
Parts Used:
DE91-70063D, 2501-001035
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Microwave would trip ac breaker
It was a over the range microwave It had to be removed off the wall. Once down I removed the bottom plate and then removed the touch control panel. Per the instructions in the user manual tested the transformer it was ok. Next tested the capacitor it tested bad and also the diode tested bad. The parts were ordered from you. The parts installed easily. Reassembled the microwave and tested. Unit no longed tripped the AC breaker and worked heating some water. Installed the unit back above the range.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Glenn from Pedricktown, NJ
Parts Used:
DE47-20059B
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
no power
took THERMOSTAT;NT-101NA,250 out and put THERMOSTAT;NT-101NA,250 in so easy got the part in LESS 19 HRS
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the MC17F808KDT
16 - 26 of 26