CVM517P2M1S1 (0000) Samsung Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Nick from Fenton, MO
- Parts Used:
- DE67-40063A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Suspect light bulb was touching glass, and cracked glass due to too much heat.
I unscrewed one screw and droped the glass light bulb cover, bent the light bulb up so it wouldn't break the glass again, removed the broken glass and installed new glass by bending the tabs over the glass to hold it in place and re-inserted the cover, then screwed the retaining screw back in. Done in 3 min.. PartsSelect.com seems to be one of the few online parts ordering place that has schematics and easy to navigate site. Perfecto!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Les from Tallahassee, FL
- Parts Used:
- DE47-20037A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Samsung oven was not heating properly. The oven baked at a lower heat (as much as 30 degrees) in the lower ranges of 350 to 450 degrees.
I had previously replaced the heating element and heat sensor to the range. The cost of replacing the thermostat was minimal. The key to replacing the thermostat is finding where it is located. Several videos describing the Samsung thermostat showed it housed under the top of the stove. This particular model places the thermostat at the back of the range near the left side. After unplugging the range, and removing the back cover with a Phillips screwdriver, it was easy to locate the thermostat. After unplugging the existing one, and using a very small flathead screwdriver to gently pry the upper and lower clips holding it in place, installation of the new thermostat was a breeze. Removing and replacing did not take more than a couple of minutes. The oven is now heating properly at all temperature settings. I would recommend finding a schematic of the range showing the location of all the parts before beginning the repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marilou from Sylmar, CA
- Parts Used:
- DE74-20016A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Microwave cooking tray cracked
We just order the tray and basically replaced it with the new one we ordered. It fits perfectly. Very happy with the purchase.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brian from SCHENECTADY, NY
- Parts Used:
- DE47-20037A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Oven wouldn’t heat to temperature after self cleaning
Pulled off the back panel (6 screws) thermostat was right there removed 2 wires and replaced with new put the panel back on done
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- SUSAN from DAVISON, MI
- Parts Used:
- DE60-30016A
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers, Wrench set
upper fan motor bad
My repair went terrible as I was sent the wrong motor 2 times. My stove sat in the middle of my small kitchen for 2 weeks. Finally the 3rd was the correct one except I didn't have the right nut so I waited another day for that to be sent. Everything working good now, I just hope the bottom fan doesn't go out after this experience.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steve from Hampshire, IL
- Parts Used:
- DE91-70063D, 2501-001035
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Microwave would trip ac breaker
It was a over the range microwave It had to be removed off the wall. Once down I removed the bottom plate and then removed the touch control panel. Per the instructions in the user manual tested the transformer it was ok. Next tested the capacitor it tested bad and also the diode tested bad. The parts were ordered from you. The parts installed easily. Reassembled the microwave and tested. Unit no longed tripped the AC breaker and worked heating some water. Installed the unit back above the range.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Glenn from Pedricktown, NJ
- Parts Used:
- DE47-20059B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
no power
took THERMOSTAT;NT-101NA,250 out and put THERMOSTAT;NT-101NA,250 in so easy got the part in LESS 19 HRS
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Juel from White Bear Lake, MN
- Parts Used:
- 4713-001165
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Bulb burned out
Replaced the bulb
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tasha from York, PA
- Parts Used:
- 4713-001165
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Light under the microwave went out
To replace the light bulb was fast and easy. All I had to do was unscrew one screw and place the bulb in! Quick and easy, and simple!
Was this instruction helpful to you?
Thank you for voting!