MW1150WA Maytag Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Jason from WASHINGTON, IN
- Parts Used:
- DE92-90189S
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Missing roller guide under glass plate
I used my pocket knife to open the package. I opened the door and removed the plate and set the guide down and put the glass plate back.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kenneth from Millsboro, DE
- Parts Used:
- WP8183592
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Bulb out
"PIECE OF CAKE" Removed cover,removrd bulb, replaced bulb, replaced cover. "PIECE OF CAKE" P.S. Wife is happy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven from Redmond, WA
- Parts Used:
- WP8183592
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Blown light bulb
You have to remove the cover which in my case was a little more difficult because the unit is wall mounted and has a frame around it. That was the hard part. Once the mounting frame was removed, you can remove the cover and the light bulb is on the top right side of the unit. One screw removes it and the new one pops right in. Put the case back on reinstall it in the wall and voila...piece of cake.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Bishopville, MD
- Parts Used:
- WP8183592
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
replace light bulb and security latch
you will a security socket T20. this unit was installed over oven, remove trim cover,remove screws holding unit in place,I used a helper to get the unit out, once out you have to remove all the screws holding the cover on,on two of the corners they use a security hex screw so you need a special socket for that. remove the door latch switch,take your time or you will break tab holding switch in. ask me how I know.but super glued broke piece in place and plugged wire back in.the new latch may have a second pin but look at old one and plug wires in the same way.the light bulb does not screw out so I had to purchase the entire unit.total cost under a $100.00 to do repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Harlan from Logan, KS
- Parts Used:
- WPM0805101, WP8183592
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
burnrd out light
Removed cover and installed light
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeanne from Terlton, OK
- Parts Used:
- WP8183592
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Screw drivers
I didn't have a recessed drive or bit
We got a a carbon steel but and drilled out the stews and put in regular screws. We also had trouble getting the cover back on and ended putting 2 more screws on the left side which had none. The installation was the easiest part of the installation.
Was this instruction helpful to you?
Thank you for voting!