LMV1680WW LG Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Krzysztof from NEW BRITAIN, CT
- Parts Used:
- 5230W1A012E
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
Leek
Change gasket
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- DIANE from PORT ORANGE, FL
- Parts Used:
- 5230W1A012E
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
The old ones broken
Took old ones out, threw away and put new ones in easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lynwood from GONZALES, LA
- Parts Used:
- 5230W1A012E, 5230W1A011E
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Change the Charcoal Filter and Microwave Grease Filter (Normal Maintenance)
Both were easy to replace. I followed the instructions in the users manual which came with the microwave. On the grease filter, I removed the 2 Phillips head screws which hold the grill plate in place. I had to open the microwave all the way to remove the grill plate. The grease filter was easy to remove and replace with a new one. I then put the grill back in and secured it with the 2 screws. Easy Peasy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from MCMINNVILLE, OR
- Parts Used:
- 3052W1A002A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Replace resin cover in microwave
Used fingers to pull damaged cover away from microwave interior body. Used fingers to snap replacement cover into open slots.
Cover snap right into special slots.
Cover snap right into special slots.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Walter J Baxter from Billings, MT
- Parts Used:
- MEB41908101
- Difficulty Level:
- Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
First problem was removing the vent cover. There were four screws that were not obvious that held the cover on. Reinstalling the cover also proved to be difficult due to alignment problems. Once that was done, the second problem was removing the door. There is a small, almost invisible, latch that h
At home on the kitchen counter.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from BIDDEFORD, ME
- Parts Used:
- MEB41908101
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Broken handle
Pulled off band unscrewed old handle and screwed on new one replace band
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Rantoul, IL
- Parts Used:
- 6549W1S013K
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
turntable wobbled
removed power cord replace turntable motor by lowering bottom panel removing two screws holding the motor on and two wires and reinstalled
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mary from SAN ANTONIO, TX
- Parts Used:
- MDX41908301
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Grill vent was broken at top and wouldn’t stay on securely
Used step stool to get to the top of the microwave, removed two top screws which attach the grill to microwave and removed broken plastic pieces under screws. Positioned new grill vent to line up screw holes, fit the plastic tongue at bottom right into slot and top guide under top frame. Inserted screws and voila -done. Good as new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Toni bc from PORT ORANGE, FL
- Parts Used:
- 4026W2A019A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Latch broken... Spring off
You Tube
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cesar from Miami, FL
- Parts Used:
- 4370W1A006B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Shaft socket was worn out
Pop old one out and replaced it with new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gregg J. from WEST CHESTER, PA
- Parts Used:
- 4026W2A019A
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Door Latch spring keeper broke
Removed door from microwave and then popped the inside widow trim ring off. Removed 4 screws from the window bracket, replaced the latch with a new part and then assembled.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marianne from CHURCH HILL, MD
- Parts Used:
- 6912W1Z004B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
light bulb replacement
very simple
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donald from Oak Ridge, TN
- Parts Used:
- 3B74133Q
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
Microwave operated but did not heat
Initial failure of over range microwave Aug 3rd. Control Panel worked but no heat. Took to local LG authoriaed local repair place. They fixed it quickly and we re-installed it. Worked fine for 2 months then had similar failure again. Agaim took to same authorized repairer. They kept unit for 3 months but finally concluded theu could not fix it and suggested we contact LG for a partial refund. When they tested the unit during re-assembly in my presence, there was a blue flash and the fuse blew. Since we had built a custom tile mural back splash around this unit, I brought it home, ordered a number of time delay fuses new capacitor and two new high voltage diodes. However, using my Fluke DMM, I checked the existing capacitor and high voltage diode and they checked OK so I just replaced the time delay fuse. The high voltage transformer leads had 2 possible ways to connect to capacitor and diode. Tried one way, plugged unit in and turned it on, and immediatly blew the fuse. Replaced the fuse and reversed the high voltage transformer connections,amd turned unit pn, and it worked perfectly. Since we had experienced several power failures during the time of the original failure, the repairer concluded that power spikes might be at fault, so I also purchased a TrippLite ISOBAR4ULTRA 3300 Joule surge protector between wall outlet and microwave, and re-installed over range. It has worked perfectly since.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from Desert Hot Springs, CA
- Parts Used:
- 6549W1S013K
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
turn table motor
remove the screws from the bottom, leave tthe light wires attached. There are two screws holding the motor on, disconnect and mark the old unit where the yellow wire goes. Mount motor with two screws and connect wires. Turn on Miicrowave for 10 sec, to be sure all is correct. Attacch bottom cover and reattach power cord. Before doing anything make sure power cord is disconnected and reattached when sealed.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dennis from Chesapeake, VA
- Parts Used:
- 2B71165R
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
No Heat
1. Removed unit from the cabinet. (2 screws). 2. Remove the outer microwave metal shell. (10 screws). 3. Locate and remove part. (3 screws). 4. Install new part and replace all screws. 5. Install unit back into cabinet. So easy. I will share this site with all of my friends.
Was this instruction helpful to you?
Thank you for voting!