Models > KHMS155LBL2 > Instructions

KHMS155LBL2 KitchenAid Microwave - Instructions

Jump to:

All Instructions for the KHMS155LBL2
121 - 135 of 209
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
JASON from ABSECON, NJ
Parts Used:
4393799
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken plate
Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Megan from Elverson, PA
Parts Used:
WP8206174
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Did not have a mounting plate with our used microwave
My husband just installed the mounting plate on the wall and the microwave was placed in position and mounted in less than 5 minutes.
Was this instruction helpful to you?
Thank you for voting!
Customer:
john from orlando, FL
Parts Used:
8184608
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Replacement Vent Grille
Very easy - 5 minutes and two screws. Just wish the fixings were more robust !
Was this instruction helpful to you?
Thank you for voting!
Customer:
George from Statham, GA
Parts Used:
4393799
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Replacement
Easy, perfect
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ralph from Sebastopol, CA
Parts Used:
8184592
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Broken Outer door panel
Removed door, removed panel, replaced panel, reinstalled door.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Justin from Folsom, CA
Parts Used:
8184592
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Cracked front panel (i.e. frame) on microwave door.
Ordered the part on PartSelect on Sunday afternoon. The part arrived on Tuesday evening. I followed the instructions on the reviews on the PartSelect site. 1. I took out the three (3) screws on the right side of the damaged panel. 2. I placed the screws in a bowl so not to lose them. 3. I pried the damaged front panel off with butter knife (it was a little harder to get off than expected). 4. I cleaned the glass. 5. I replaced the glass in the mounts on the new front panel. 6. I snapped the front panel into place and reinserted the screws. Boom. Done. I threw away the damaged front panel. I don't think it was recyclable.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Otha from Missouri City, TX
Parts Used:
6802A, 6800
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
replace grease and charcoal air filters
Remove old filter & insert replacement filters
Was this instruction helpful to you?
Thank you for voting!
Customer:
Randall from Washington, IL
Parts Used:
6800
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Replace charcoal filters in microwave - vents inside.
Remove the screws holding the bottom vent plate to the upper unit, using a Phillips head screwdriver. Loosen a front screw last, but don't remove it. While supporting the plate in one hand, unscrew the final screw with the other. Lower the front of the bottom plate - tabs in the rear will prevent the plate from falling out. Bend the outer tabs holding the old filters in place, to allow them to be slid out. Insert the new filters & bend the tabs back into locking position. Raise the bottom plate and finger tighten a front screw. Replace and tighten all screws. This is also a simple way to remove/clean/replace the mesh filters. I've pulled the D-rings off trying to slide them out from below.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Andrea from Fresno, CA
Parts Used:
8184608
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
old vent grille brackets broke off
Super easy! Just unscrewed remainder of the vent grille, saving the old screws as instructed on other reviews I read, and replaced vent grille with perfectly fitting new one...whole process took 15 min (while 9 months pregnant with a toddler hanging on my leg!) And partselect sent the piece with regular shipping in 2 days!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cheryl from Chula Vista, CA
Parts Used:
8184608
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Part missing
This rental unit was missing the vent grille for the mounted microwave. It was super simple to install and makes the microwave look like new.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jennifer from Red Oak, IA
Parts Used:
8204670
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Light burned
Unscrewed the lens cover anbd inserted the new bulb. Put the cover back on and there was light!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sharon from Anoka, MN
Parts Used:
8204670
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
burned out overhead light
Some difficulty getting screw loosened, once that was done replaced burned out bulb.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Marcelene from Cuyahoga Falls, OH
Parts Used:
8184608
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
grille kept falling off until tabs broke
Looked at the original instruction manual to see how it was installed, removed the two Phillips screws, fitted the grille into position until correct, then replaced the two screws.
Was this instruction helpful to you?
Thank you for voting!
Customer:
THEODOROS from VIRGINIA BEACH, VA
Parts Used:
6802A, 6800
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
replacement of filters
just replaced the filters
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lawrence from Excelsior, MN
Parts Used:
W10435116
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
rotating glass dish assembly making stange noise
The lady in the Nova Scotia call center should get all the credit for being able to identify the part I needed from only the very limited information I was able to give her. Employee of the month for her. She also had such a great can do attitude. Lawence Baier
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the KHMS155LBL2
121 - 135 of 209