KHMS1850SWH0 KitchenAid Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Hild, from STRONGSVILLE, OH
- Parts Used:
- W10250593
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Easy fix
The part is held in place with two screws. A poor design for sure. The replacement part is a direct fit once the two screws are removed. Reuse the same screws, don't order new ones.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Theresa from OVERLAND PARK, KS
- Parts Used:
- 8206232A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Burned out bulb
Husband replaced the bulb
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Vince from LAHASKA, PA
- Parts Used:
- W10250593
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Plastic holders cracked causing the Vent Grill to completely separate from th Microwave.
Repair took kess than 5 munutes.. Align plastic guides for the Screws and using a Philips screwdriver commence to tightening same .
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jerry from Pine, CO
- Parts Used:
- 8206232A
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Replacement of hood light bulbs
Unplug the microwave. Then remove the six screws that hold the lower panel which has the light bulb cover and a couple of vent filters. The light bulb sockets are on a fixture that is connected by a quick connect electrical connector. Disconnect that and the whole panel is free to access the bulbs. My bulbs were very fragile and trying to twist them out resulted in the glass twisitng loose with the base still in the sockets. I needed to use a needle nose pliers to remove the bases and then I replaced the bulbs and put every thing back together
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- DANNY from SAINT JOHNS, FL
- Parts Used:
- 8206232A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Burned out light in microwave
Spouse just screwed in the new bulb and reinstalled the light cover plate with the two screws. Took under a minute. Works great.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Emily C from Brandon, MS
- Parts Used:
- 4393799
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Dropped the glass cooking tray and it broke in half
Looked up the Whirlpool Co. and ordered the part. It was quite simple. Arrived in 2 days and I simply placed it in the microware. It was very very easy!
E. Robinson
E. Robinson
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brian from Washington, DC
- Parts Used:
- W10113040A, W10112514A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Replaced microwave filters
Replacement was easy as outlined in the microwave manual.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kathleen from ROY, WA
- Parts Used:
- W10250593
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Replace vent grille
Set in place and installed 2 screws. Took less than 5 min.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- CARMELO from LOVETTSVILLE, VA
- Parts Used:
- W10709921
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Both lights failed. Replaced with new bulbs.
Unscrew lens and direct access to surface light cavity. Removed old light bulbs and replaced with new bulbs. Reassembled lens cover and turned lights on successfully. Took less than ten minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Hendrika from Campbell, CA
- Parts Used:
- W10112514A
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
replacement of charcoal filters in microwave
This wasn't really a repair, just an replacement of the filters, which is a regular maintenance requirement.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- NANCY from CHICAGO, IL
- Parts Used:
- W10250593
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Plastic tabs sheared off screws
Removed old screws and pieces of plastic. Replaced new grill vent with old screws. Could not have been any easier
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rick from Ormond Beach, FL
- Parts Used:
- W10250593
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Grill vent was broken
All it took was 2 screws and it was done - could not have been simpler.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- judith from holland, PA
- Parts Used:
- W10250593
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
broken plastic attachment for vent grill cover
Replacement of new vent grille took less than 5 minutes. I just wished Kitchen Aid made a product that lasted longer than 3 years. My part arrived very quickly, less than a week. Service was great and so was your price. I had no problem locating a replacement part. Kitchen Aid would not give me the parts number so I did not know if I was order the right part. But you photo really helped to narrow the correct part. Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dwight from Los Lunas, NM
- Parts Used:
- W10250593
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Plastic mounting bracket broken heat/stress
Remove two screws, remove grill/bracket, replace grill/bracket, replace two screws and your done. Recycle if You Can.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from EXETER, NH
- Parts Used:
- W11252182
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
One of the wheels came off
Took out turntable and swapped out old one with a new bright and shiny
New one, ring that is. It was easy using the part from parts select
Thanks
Paul
New one, ring that is. It was easy using the part from parts select
Thanks
Paul
Was this instruction helpful to you?
Thank you for voting!