KHMS147HBT1 KitchenAid Microwave - Instructions

After researching online, I found that I needed the turntable drive coupling, part#PS993087. when I went to your site it showed the same part but the part number had changed but said it would fit my microwave. Well, I was really surprised and happy when the part I received 3 days after I placed the order, with normal shipping,fit perfectly and now my turn table in my microwave works. I have marked this site a a favorite and will use it I'm sure soon. Being a single women and having to figure out how to fix the things on a small buget, I'm learning a lot and have a lot of respect for men that know how to do all the repair stuff. Thanks so much, I have been able to mark this off my list of things to fix. Have a nice day. Cj- age, 58

Super easy! Just unscrewed remainder of the vent grille, saving the old screws as instructed on other reviews I read, and replaced vent grille with perfectly fitting new one...whole process took 15 min (while 9 months pregnant with a toddler hanging on my leg!) And partselect sent the piece with regular shipping in 2 days!

This rental unit was missing the vent grille for the mounted microwave. It was super simple to install and makes the microwave look like new.

The lady in the Nova Scotia call center should get all the credit for being able to identify the part I needed from only the very limited information I was able to give her. Employee of the month for her. She also had such a great can do attitude. Lawence Baier

Ordered the item on a Monday at 12pm and it arrived the next day. Amazing!

just replace need cooking tray

Followed the instruction booklet that came with the microwave. Very easy.

Ordered the part on PartSelect on Sunday afternoon. The part arrived on Tuesday evening. I followed the instructions on the reviews on the PartSelect site. 1. I took out the three (3) screws on the right side of the damaged panel. 2. I placed the screws in a bowl so not to lose them. 3. I pried the damaged front panel off with butter knife (it was a little harder to get off than expected). 4. I cleaned the glass. 5. I replaced the glass in the mounts on the new front panel. 6. I snapped the front panel into place and reinserted the screws. Boom. Done. I threw away the damaged front panel. I don't think it was recyclable.

Very easy - 5 minutes and two screws. Just wish the fixings were more robust !

Installation was very easy and only took about two minutes. I am extremely pleased.

Easy, perfect

Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.

My husband just installed the mounting plate on the wall and the microwave was placed in position and mounted in less than 5 minutes.

Remove old filter & insert replacement filters

Remove the screws holding the bottom vent plate to the upper unit, using a Phillips head screwdriver. Loosen a front screw last, but don't remove it. While supporting the plate in one hand, unscrew the final screw with the other. Lower the front of the bottom plate - tabs in the rear will prevent the plate from falling out. Bend the outer tabs holding the old filters in place, to allow them to be slid out. Insert the new filters & bend the tabs back into locking position. Raise the bottom plate and finger tighten a front screw. Replace and tighten all screws. This is also a simple way to remove/clean/replace the mesh filters. I've pulled the D-rings off trying to slide them out from below.