KHHS179LSS0 KitchenAid Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- brian from tucson, AZ
- Parts Used:
- 8185156
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
door handle broken
The screws broke out of the handle. After replacing it with a new one I realized a cheep fix would have been to get longer screws because in the broken handle there was still plenty of thread left. I ordered a new one from Part Select and received it in four days. You first need to remove the black plastic choke around the inside of the door, I used a small flathead screwdriver then remove the two screws on the side of the door. Then with a flathead screwdriver unclip the metal frame from the door skin. Be careful though because at this point the panel can fall out the back. Then move the foam insulation and loosen the screws. Screw in the new handle and the rest snaps right back into place. I would not recomend hiring someone to do this. Its a 15 minute doit yourself project.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larrt from Minooka, IL
- Parts Used:
- W10642989
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Microwave turntable stopped rotating.
1. Unplug the power cord from the wall socket. 2. Remove the 10 screws holding the bottom cabinet cover in place. The bottom cabinet cover will swing down allowing acces to the inside ofe the microwave. 3. Remove the connector from the turntable motor. 4. Use a T15 Torx driver to remove the 2 Torx screws holding the motor in place. 5. Remove the motor. 6. Reverse the process using the new motor.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dotty from Hillsboro, WI
- Parts Used:
- 8204670
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
surface light on microwave wasnt' working
took the light assembly off and replaced the bulb and put the assembly together and fitted back in the space and finished the assembly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- joshua from las vegas, NV
- Parts Used:
- W10189669
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers, Socket set, Wrench set
Door would not shut
Had to replace 1 latch in order for the microwave door to close.
Was this instruction helpful to you?
Thank you for voting!