KHMS155LBL3 KitchenAid Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Amber from Loretto, PA
- Parts Used:
- 4393799
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The glass tray in the microwave got chipped while i was washing it and started to crack.
I just opened the box and set it in. Took all of two minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JASON from ABSECON, NJ
- Parts Used:
- 4393799
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken plate
Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Megan from Elverson, PA
- Parts Used:
- WP8206174
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Did not have a mounting plate with our used microwave
My husband just installed the mounting plate on the wall and the microwave was placed in position and mounted in less than 5 minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Randall from Washington, IL
- Parts Used:
- 6800
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Replace charcoal filters in microwave - vents inside.
Remove the screws holding the bottom vent plate to the upper unit, using a Phillips head screwdriver. Loosen a front screw last, but don't remove it. While supporting the plate in one hand, unscrew the final screw with the other. Lower the front of the bottom plate - tabs in the rear will prevent the plate from falling out. Bend the outer tabs holding the old filters in place, to allow them to be slid out. Insert the new filters & bend the tabs back into locking position. Raise the bottom plate and finger tighten a front screw. Replace and tighten all screws. This is also a simple way to remove/clean/replace the mesh filters. I've pulled the D-rings off trying to slide them out from below.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrea from Fresno, CA
- Parts Used:
- 8184608
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
old vent grille brackets broke off
Super easy! Just unscrewed remainder of the vent grille, saving the old screws as instructed on other reviews I read, and replaced vent grille with perfectly fitting new one...whole process took 15 min (while 9 months pregnant with a toddler hanging on my leg!) And partselect sent the piece with regular shipping in 2 days!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cheryl from Chula Vista, CA
- Parts Used:
- 8184608
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Part missing
This rental unit was missing the vent grille for the mounted microwave. It was super simple to install and makes the microwave look like new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jennifer from Red Oak, IA
- Parts Used:
- 8204670
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Light burned
Unscrewed the lens cover anbd inserted the new bulb. Put the cover back on and there was light!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharon from Anoka, MN
- Parts Used:
- 8204670
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
burned out overhead light
Some difficulty getting screw loosened, once that was done replaced burned out bulb.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marcelene from Cuyahoga Falls, OH
- Parts Used:
- 8184608
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
grille kept falling off until tabs broke
Looked at the original instruction manual to see how it was installed, removed the two Phillips screws, fitted the grille into position until correct, then replaced the two screws.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lawrence from Excelsior, MN
- Parts Used:
- W10435116
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
rotating glass dish assembly making stange noise
The lady in the Nova Scotia call center should get all the credit for being able to identify the part I needed from only the very limited information I was able to give her. Employee of the month for her. She also had such a great can do attitude. Lawence Baier
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stephanie from La Jolla, CA
- Parts Used:
- 4393799
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broke a 15 year old glass cooking tray
Ordered the item on a Monday at 12pm and it arrived the next day. Amazing!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- janice from dunn, NC
- Parts Used:
- 4393799
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
glass cooking tray droped and broken
just replace need cooking tray
Was this instruction helpful to you?
Thank you for voting!
Broken turntable support ring and missing support
Watched video which reminded me to order support for the turntable support ring and did exactly what the person in the video did. Excellent and prompt service and all parts fit.
Was this instruction helpful to you?
Thank you for voting!