66563799305 Kenmore Microwave - Instructions

Remove the microwave from its mount above the stove. Remove the sheet metal top/sides piece. Pop the control panel loose to allow access from the front. Remove more screws that will allow the small inverter to be removed and the big inverter housing to be wrangled loose enough to remove the big inverter. Pop the inverter cooling fan from its mount. Disconnect wires and remove screws to remove big inverter. Install new inverter in reverse process.

Don't waste your time with other parts stores online. Partselect sells quality parts and they arrived 2 days early. I purchase a door switch from another online store and the switch was defective.

Open door and remove vent cover buy pulling gently. Next un plug the microwave. emove the screw at the top of the control panel. Slide the control panel straight up until the hooks on the sides slip out of the slots. Tip the panel toward you and unplug the three different plugs near the top of the panel. Now the panel will tip further out and it can be moved around to get the metal catch at the bottom to come out of the slot. This will let the panel tip down to a horizontal position making it easier to work on. Remove the one screw that holds the circuit board to the plastic rack. There are three tabs that hold it in place but all of mine were broken off. Next remove the three screws that hold the plastic rack and the screw that holds the grounding wire. Lift the circuit board up and slide the old plastic rask out. Don't forget to unplug the sensor light from the rack. Slide the new rack in place and snap the circuit board onto the new rack. Replace all screws, put the control panel back into the slot then put the hooks on the sides back into their slots, replace the screw at the top. Put the vent cover back on, plug it in and go have a beer.

easy to replace, just the same as cleaning the turntable and placing back in the micorwave;

I removed the broken tray and ring-turn and replaced it with the new
Service was fantastic, parts were ordered one day and received the next

Washed the glass tray and put in the microwave oven. Easy..

Rep knew exactly what I needed when I described where the part should go on my microwave - price great - shipping great - installed in seconds. Thank you!

I ordered the handle and one screw (I thought they were 2 per pack). I removed the handle and replace it using the new screw and one of the old screws. It was VERY easy.

I ordered another one and placed it inside the microwave. It works and fits perfectly. I received the order exactly as scheduled.

Replaced the supports and rack.

Removed turntable
Place support ring in track
Place turntable on support ring.
Easy, peasy!

Looked up the Whirlpool Co. and ordered the part. It was quite simple. Arrived in 2 days and I simply placed it in the microware. It was very very easy!

E. Robinson

The top of the handle was fine and the screws that held it in place are totally accested from inside the door(2 screws).The bottom 2 screws are 'hidden' by the inside of the door. You don't have to remove the door itself(unless you want to), but you do have to remove the inner door panels (there is a black band between the 2 white door pieces) to access the 2 remiaining screws. I found that a putty knife was a good tool to use. Work from the hinge part of the door to the handle end. The top was easier than the bottom? Once the back is loose enight to access the bottom screws you are basically done. Screw in the new handle with the old screws(hope you didn't thro them away). Reassemble the back(inside) of the door. Just put the black band on the glass portion and push back together.

used screw driver to pry up old part. lifted right off. line up drive couple drive push on. repair took less than 1 minute to repair. works like new
Very Pleased with Parts Select replacement parts

First, we had to clean up all the interior surfaces, which was just cleaning. There was no internal damage. Then, just setting the center connector, rotary rollers and glass plate. Simple