66560629000 Kenmore Microwave - Instructions

It was a bit awkward because the microwave is mounted over my stove. I had to twist around and install the bulb and then replace the cover. It was a bit uncomfortable. It took me about 10 minutes to complete.

Backed out the screws, removed cracked grille. Installed new perfectly matched grille, screw down. Done.

Remove 6 screws, remove glass and black molding. Then I placed those items in the new frame. Placed the frame on the Hinges and replaced the screws. It was that easy.

Overall a very easy fit, the key for me was being gentle with the glass if your door has an extreme crack (as mine did). If it does, the glass can easily fall out of the frame. The plastic clips that hold the glass to the frame are also quite fragile, so just gently work the glass into the clips without forcing it.

Took me about 20 minutes.

1) Remove 3 screws from side of door
2) Remove 2 screws from bottom of door
3) Carefully slide outer frame of of door.

If crack is extreme (as mine was), be careful that the glass does not completely fall out when removing frame

4) I used a putty knife to carefully pry up the top part of the frame as it has clips that fit into slots on the door.
4)Once frame is removed use screwdriver to remove door handle
5) Remove glass from frame and replace with new one. Use the putty knife to gently push the clips onto to it as the plastic clips that hold the glass look easily breakable
6) Re-attach door handle
7) Slide new frame back onto door, push top clips down into door top and replace all screws

ordered supplies on line (awesome!) Took apart old door added new frame. It was a snap!

Take off top facing over microwave using screwdriver also protection plate for diode and capaitor. Disconnect diode from frame, bracket to capacitor then remove, disconnect wires leaving diode on capacitor for right connection, replace, rewire done.

Piece of cake. One screw to release the dropdown light diffuser. Just remember, the you're screwing the new bulb in from a reverse perspective. Also this site sends the correct part the first time.

Removed the microwave from above the oven by loosening the two screws above the microwave. As the unit tilted outward lifted up and the whole unit came out all the time feeding the power cord through the cutout for the power cord. After it was out removed the cover and identified the capacitor and made sure it was discharged and removed and replaced the diode. tested before reinstalling and it heated up just fine. Reversed order and reinstalled . Very easy job maybe a second hand to help fish the power cord when installing and removing.

Put s pot under were you take the screw out.If you drop it you can get it easy

Remove “over the stove” unit. Remove unit shell case. Unscrew and disconnect diode. Replace diode. Re-assemble. Put unit back in place.

Really easy for a 75-year old female; just spent more time reading the online manual than actually installing the light bulbs to find out where to access the light bulbs.

Turn off power supply at breaker . Replace old bulb with new bulb .

We needed a phillips head screw driver to remove the single screw holding the light bulb cover in place.
Removing the old bulbs was a little work, because they had come loose from the sockets. We unplugged the microwave, so we could grip the sockets with a tool. I think my husband used a needle nose plier for this.
The new bulbs screwed in easily, and then we refastened the light bulb cover with the phillips head screw driver.

screwed in new bulb

I was able to buy the mounting bracket for a very cheap price and was able to instill it in my kitchen with ease.
Thank you