66561627100 Kenmore Microwave - Instructions

just replace need cooking tray

The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.

Easy, perfect

Watched video which reminded me to order support for the turntable support ring and did exactly what the person in the video did. Excellent and prompt service and all parts fit.

After researching online, I found that I needed the turntable drive coupling, part#PS993087. when I went to your site it showed the same part but the part number had changed but said it would fit my microwave. Well, I was really surprised and happy when the part I received 3 days after I placed the order, with normal shipping,fit perfectly and now my turn table in my microwave works. I have marked this site a a favorite and will use it I'm sure soon. Being a single women and having to figure out how to fix the things on a small buget, I'm learning a lot and have a lot of respect for men that know how to do all the repair stuff. Thanks so much, I have been able to mark this off my list of things to fix. Have a nice day. Cj- age, 58

Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.

My husband just installed the mounting plate on the wall and the microwave was placed in position and mounted in less than 5 minutes.

You had alerted that it was imperative to unplug unit before starting to remove defective bulb. As described, there was silicon on bulb and socket and bulb broke upon my attempt to remove. Had to use needle nose pliers to get metal base of old bulb from socket, then all went well.

Remove old filter & insert replacement filters

Remove the screws holding the bottom vent plate to the upper unit, using a Phillips head screwdriver. Loosen a front screw last, but don't remove it. While supporting the plate in one hand, unscrew the final screw with the other. Lower the front of the bottom plate - tabs in the rear will prevent the plate from falling out. Bend the outer tabs holding the old filters in place, to allow them to be slid out. Insert the new filters & bend the tabs back into locking position. Raise the bottom plate and finger tighten a front screw. Replace and tighten all screws. This is also a simple way to remove/clean/replace the mesh filters. I've pulled the D-rings off trying to slide them out from below.

I called the repair/parts number to make sure I had correct parts and the young lady instructed me as to the size of the serving tray; within 48 hours we had the VERY carefully wrapped carton opened and back in the microwave, working perfectly. Thank you. We'll recommend you to our friends!

Slid them out and slid them in. Best part - ordered them at Noon on the Friday after the 4th of July and they arrived at 12:10 the next day - standard shipping.

Replaced light bulb.

removed old frame by taking apart 5 screws, took out glass and inner frame from old outer frame. Old glass and inner frame fit right back in to new outer frame. 5 screws back together!!

removed grill cover, removed bulb plate, unscrew bulb, screw new bulb in socket,put bulb cover back on and screw grill cover back on. no issues whatsoever.