JMV8208BCB17 Jenn-Air Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Glenn from Pedricktown, NJ
- Parts Used:
- DE47-20059B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
no power
took THERMOSTAT;NT-101NA,250 out and put THERMOSTAT;NT-101NA,250 in so easy got the part in LESS 19 HRS
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tasha from York, PA
- Parts Used:
- 4713-001165
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Light under the microwave went out
To replace the light bulb was fast and easy. All I had to do was unscrew one screw and place the bulb in! Quick and easy, and simple!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Simsbury, CT
- Parts Used:
- DE63-00367D
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
change old filter
replace filter according instruction
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steve from Hampshire, IL
- Parts Used:
- DE91-70063D, 2501-001035
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Microwave would trip ac breaker
It was a over the range microwave It had to be removed off the wall. Once down I removed the bottom plate and then removed the touch control panel. Per the instructions in the user manual tested the transformer it was ok. Next tested the capacitor it tested bad and also the diode tested bad. The parts were ordered from you. The parts installed easily. Reassembled the microwave and tested. Unit no longed tripped the AC breaker and worked heating some water. Installed the unit back above the range.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mike from Paso Robles, CA
- Parts Used:
- WPW10126786
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers, Wrench set
microwave acts like its working but won't heat.
Replaced the magnetron and diode. Microwave works prefect now.
Was this instruction helpful to you?
Thank you for voting!