Models > JMV9196CB0 > Instructions

JMV9196CB0 Jenn-Air Microwave - Instructions

Jump to:

All Instructions for the JMV9196CB0

Customer:: Glen from GLIDDEN, WI
Parts Used:: W11025649
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers

Mounting plate support edge broken

I removed the microwave to install a back splash and found the support edge on the backplate had broken off and was missing. I searched for parts for the microwave and found them on PartsSelect.com. Easy to order, and was shipped promptly.

Once the part arrived, install was simple, lining up the existing holes. The only hard part was setting the microwave up on the bracket due to the weight and awkwardness of the microwave.

Overall a very simple repair.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Mike from BURNSVILLE, NC
Parts Used:: W11402532
Difficulty Level:: Very Easy
Total Repair Time:: Less than 15 mins

broke thw carosel plate

took it out of box wooolaaa fixed thanks fast shipping too...

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: George from SANFORD, FL
Parts Used:: W11025649, W10821385
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins

I had a cabinet person install new kitchen cabinets and counter top. After the demolition of the the old cabinets, I had to buy new parts for the new instal

I had the help of a handyman, I'm 75 years young but not handy with tools

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Richard L from PRESCOTT VLY, AZ
Parts Used:: 8206230A
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Charcoal Filter getting old, needed replaced

Removed the face plate above the door (2 Phillips screws.) Removed existing filter and replaced with the new one purchased. Reinstalled the face plate.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Theodore from SEBRING, FL
Parts Used:: W11025649, W10190018
Difficulty Level:: Very Difficult
Total Repair Time:: More than 2 hours

Wrong mounting plate

Two Mounting plates # PS12074431 were sent to me and both do not fit.
Model number MMV1175JZ-0
Serial number TRX-17. 24546
Manufactured April 2020
Contacted Maytag and even sent pictures to show the problem with alignment of the mounting plate not fit in the back of the microwave.

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Larry from HARKER HTS, TX
Parts Used:: W11707984
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Pliers

Microwave had no electrical

I was sent the wrong fuse by you. I had to procure a fuse in another manner. Very disappointing. The repair was simple. It just took longer because of the failure to send the correct fuse.

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: RaviShankar from Artesia, CA
Parts Used:: W11256462, 8206230A
Difficulty Level:: Easy
Total Repair Time:: 1- 2 hours
Tools:: Pliers, Screw drivers

On Turning on the Microwave, it was sparking, was not sure where the sparks are coming from, initially I thought mica at the end of megnatron duct could be the issue

when I opened the back cover of microwave, the diode was kind of blackish blown, since there was light bulb and fan were still working, i thought it could be problem with any one of the components like; magnatron or capacitor or diode, so first replaced the diode and mica at the end of the magnatron duct, there was problem with door switch as well. i fixed that too. Now it is working. It cooks bit faster, Wondering why?

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Mary from Wilmington, OH
Parts Used:: W10337248
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

The support became distorted and needed to be replaced.

I simply lifted out the glass rotating plate and inserted the new support. How complicated can that be?!!!!!!!!!!!!!!!!!!!!!!!!!!!

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Charles from Meridian, MS
Parts Used:: 8206230A
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Charcoal Filter Replacement

This is an under the counter microwave. Simply removed the two screws holidng the vent grille on top of the unit, lift out the old charcoal filter, clean the vent fan exit surfaces then replace the filter and put the vent grille back. Be careful to not drop either of the two screws after one is installed as you will have to take the grill off and start the screw installation again unless you have a magnetic to retrieve the dropped screw. An easy five minutes at most to change.

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Herb from Auburn, IN
Parts Used:: W11707984
Difficulty Level:: A Bit Difficult
Total Repair Time:: 1- 2 hours

it was working fine and it stopped order a fuse and it wasn't the problem

took it to Buttermore appliance in Auburn Indiana and he changed the fan and added another fuse

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Stephen from SPRINGFIELD, WV
Parts Used:: W11707984
Difficulty Level:: Very Difficult
Total Repair Time:: 1- 2 hours
Tools:: Pliers, Screw drivers

Put the Fuse in, then plugged it in came on for a min then everything went out!!!!!

Took the front off and behind a plate was the fuse, so I replaced it for what good that did!!!

4 of 16 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Edward from Oakland, NJ
Parts Used:: 8206230A
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

changed filters

Replaced filter which came inrecord time.

Was this instruction helpful to you?

Customer:: John from Denver, CO
Parts Used:: W10208631A, 8206230A
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Filter dirty

I unscrewed the filter cover, replaced the charcoal filter and replace the cover. The other wire mesh filter slides right into place. You sent me the right parts for my filter replacement on my microwave. Easy install. Thanks

Was this instruction helpful to you?

Customer:: linda from brockton, MA
Parts Used:: W10709921
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

I noticed that the hood lights were out.

I took off the glass panel underneath the microwave and replaced the 2 bulbs in less than 3 minutes by myself with only a phillips head screwdriver. I was very pleased with the service I received and more pleased with myself that I did not have to call in a repair man.

Was this instruction helpful to you?

Customer:: Barbara from Cranston, RI
Parts Used:: W10208631A
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins

replace filter

slide into place under hood

Was this instruction helpful to you?

All Instructions for the JMV9196CB0