Models > JVM1728SMC01 > Instructions

JVM1728SMC01 General Electric Microwave - Instructions

Jump to:

All Instructions for the JVM1728SMC01
121 - 135 of 145
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Martha from Anaheim, CA
Parts Used:
WB06X10130
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
microwave will not come on
I replaced the cover just fine but i think a sensor went bad
Was this instruction helpful to you?
Thank you for voting!
Customer:
Greg from Boone, NC
Parts Used:
WB26X10208
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Turntable stopped turning
Removed the bottom panel from the microwave. Check to see if there was still power going to the turntable motor. There was still power there. Looked up the microwave model# on the website which showed a full display of the microwave parts. Selected the part. When the part arrived. Removed the bottom panel off the microwave. Removed the 2 screws holding the turntable motor in place. The new turntable motor was slightly different so I did have to cut a small slot in the new turntable motor so it would slide into the punched out slot so it would sit in the correct position. The job was still very easy and I complete the repair in about 20 mins. It was great to be able to do the repair myself and saved me some dollars. I would definitely recommend PartsSelect.com to anyone.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Barbara from N Chesterfield, VA
Parts Used:
WB26X10208
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Turntable not working
Easy. A little awkward getting to the part since microwave is over stove and not much room between range and microwave. Other than that, it was a piece of cake.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ISAAC from MADAWASKA, ME
Parts Used:
WB49X10129
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken Glass Tray
Very easy replacement. Just lift out and replace with a new one!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Elaine from Pittsburgh, PA
Parts Used:
WB36X10003
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
over range top light bulbs burned out
My son had to replace the bulbs because the screw that holds the bulb shield was so tight that I couldn't remove it. It was too difficult for me to do it myself.
Was this instruction helpful to you?
Thank you for voting!
Customer:
jerry from gulfport, MS
Parts Used:
WB36X10071
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
glass broken
replaced the glass
Was this instruction helpful to you?
Thank you for voting!
Customer:
Nicole from Lathrop, CA
Parts Used:
WB49X10129
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
drop and shattered the glass tray
It was so easy to order the part on this website. It came carefully packaged and quickly! Thank you!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ralph from Puyallup, WA
Parts Used:
WB49X10129
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Glass tray broke in microwave
Removed tray from shipping container and installed in the microwave.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the JVM1728SMC01
121 - 135 of 145