Models > DVM1950SR1SS > Instructions

DVM1950SR1SS General Electric Microwave - Instructions

Jump to:

All Instructions for the DVM1950SR1SS
76 - 90 of 90
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Timothy from Middletown, NJ
Parts Used:
WB24X829
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Wrench set
Light worked, timer and control pad worked, but no turntable, no heat, no noises of any sort, just didn't start up
It was a snap using the instructions given. The key is getting into the unit. I did have to use a multimeter to find the failed switch since there are two of that type.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Andrew from ScotttsDale, AZ
Parts Used:
WB49X10063
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Broken platter in micro wave
Very easy ordered on line placed it in microwave
Was this instruction helpful to you?
Thank you for voting!
Customer:
jerry from gulfport, MS
Parts Used:
WB36X10071
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
glass broken
replaced the glass
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeffrey from Gaithersburg, MD
Parts Used:
WB27X10597
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Screw drivers
Oven failed to heat food.
Remove the microwave cover. Requires a phillips screwdriver and a torx security bit/nut driver (there are two security type screws on the back...guess they don't want you to do this at home!). I had to buy the a security bit set (about $7). The diode is easily accessible on the right side under the fan. Requires removing on small phillips screw and unplugging on electrical connection. GE provides some instructions in an envelope on top (after cover removed). There is a warning/instruction to discharge the capacitor before service. This was not a problem for me. Actual diode replacement took 30 seconds. Whole job = 15 minutes.
Was this instruction helpful to you?
Thank you for voting!
Customer:
charlie from spring, TX
Parts Used:
WB24X830, WB24X829
Difficulty Level:
Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
no hot
every thing is working, but no hot
Was this instruction helpful to you?
Thank you for voting!
Customer:
Vita from Flagstaff, AZ
Parts Used:
WB24X830, WB24X829
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
would not turn on - plug in and would shut off right away
thank you very much.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Phillip from Umatilla, FL
Parts Used:
WB24X829
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Unit would not come on.
removed access panal, found soft switch as discribed on your web site. removed and replaced.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DVM1950SR1SS
76 - 90 of 90