JVM1631BJ01 General Electric Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Michael from East China Township, MI
- Parts Used:
- WB27X10928
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
All power to the microwave went out.
PartSelect had helpful repair instructions on-line which made the repair easier and faster. Unfortunately, there were other problems with the oven that immediately blew the new fuse I had just installed. It was then determined that additional repair would most likely cost almost as much as a new microwave.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marc from Edmond, OK
- Parts Used:
- WB07X10967
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
top of the grille screw bracket broke
took off the old grille and put new one on and lined it up properly and screwed it in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Littleton, CO
- Parts Used:
- WB24X10047
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Pliers, Screw drivers
Door Interlock Switch Failed
Removed cover, diagnosed problem, ordered part from Parts Select, received part in 2 days, replaced part, tested and replaced oven into built in space.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brian from Minneola, FL
- Parts Used:
- WB26X10135
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Wrench set
microwave turntable not working
working changed out the motor that arrived within 2days. Great Service and thank you so much.Brian Kerry
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Scott from Clovis, CA
- Parts Used:
- WB56X10430
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Broken Lower Microwave Door frame
When the part arrived I took it from the mailing container. I looked at the door and made sure the part wasn't damaged and looked at the broken one to be repaired to get an idea of how I'd approach the repair . I realized that I'd need something to lift the door from the holding pin. I got a flathead screwdriver and put a little pressure on the door near the bottom hinge. As I put pressure on the white hinge and the door the pin slid back off the white support. I did the same on the top, to remove the door completely. Needless to say, putting the new door on was easier than taking it off. You can do this without a headache.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Danny from Louisville, KY
- Parts Used:
- WB36X10328
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
lights were burned
It was REALLY EASY finding the right parts using your diagrams..Thanks for your HELP!!I will definitely be back.Dan H
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from Keizer, OR
- Parts Used:
- WB55X10813
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The front door decritive trim frame broke off
FIRST OFF I'd Like to say. I phoned my cities Appliance Repair Specialist. He didn't return my call. I rephoned and got him. Told him I need the Door frame. He said GE would make me buy the entire door so just by a new Microwave from him. I went online and this was the first sight I found. Typed in my Make and model number and up popped a scematic. I hit on Door and there it was all layed out in pieces. I hit the front door frame and BOOM Payed for it and two days later it was here. BRAVO to you folks. Since most of the front trim frame had fallen off I just had to pull a little around the outer edges to get the rest of it off. I noticed when I ordered the New Part from you that the front door handle was held on by two screws from the backside of the door. When I looked and couldn't see them I knew they had to be under the inner plastic frame work on the backside of the door. SO I kind of pulled on it at various places around it's edges and it started to pop OFF and I worked it off. Removed the screws and handle that held that last part of the front trim frame. Snapped in the new one. Reinstalled the door handle and snapped the rear door panel back on and it was DONE!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Janet from Fairview, TX
- Parts Used:
- WB02X35607
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Dirty charcoal filter
Open vent, removed old filter, inserted new filter.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Roanoke, VA
- Parts Used:
- WB26X32629
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Microwave would not heat
I went on line, put in microwave repair and watched a video on repair. I then took the oven down from over the range and took it apart. I could see were the magnetron had burned out. There was a hole with obvious burn marks. I went on line looking for the needed part. I clicked on PartSelect and order the magnetron. I received the part within three days, regular shipping. As I had not put the oven back together it took only a few moments to save 150 to 200+ dollars. I put it back together and happy, happy me, it worked.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Dittmer, MO
- Parts Used:
- WB06X10689, WB49X10176
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
missing parts
open box and installed
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Medford, NJ
- Parts Used:
- WB07X10967
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Grill vent broke and fell off.
Microwave had to be dropped down about 3 inches from the mount,two upper screws removed replaced old vent with new and replaced screws but didn't make them too tight.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stephanie from Kernersville, NC
- Parts Used:
- WB27X10928
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
microwave won't heat
bought a fuse but that didn't solve the problem. Guess I need a new microwave
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bonnie from Lutz, FL
- Parts Used:
- WB49X10176
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken turntable
just opened the microwave door and inserted tray
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- connie from des moines, IA
- Parts Used:
- WB49X10176, WB06X10576
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Turntable shaft and glsss turntable needed replaced
Removed the shaft that holds the glass turntable and replaced with new one and also installed new glass turntable. I am not sure if grease had gotten down under the turntable or what had happened. My son had cooked bacon in microwave and maybe grease got down underneath turntable and glass looked like it had cracks around the center and the shaft to hold it looked damaged. Was happy to be able to replace the 2 items. Thank you.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph from Alplaus, NY
- Parts Used:
- WB15X10120
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
door handle broke
after ordering handle-R, I needed handle-L also, not knowing the handle was two pieces. hardest part was putting the two pieces of handle together.
Was this instruction helpful to you?
Thank you for voting!