DENNIS General Electric Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Rich from Baltimore, MD
- Parts Used:
- WB39X75
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Floor of microwave cracked
Removed the broken pieces of the microwave floor and placed the new one in, careful that the gasket didn't slip off.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Yorktown Heights, NY
- Parts Used:
- WB27X10585
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
loud hum & the microwave quit working
remove the housing,replaced the magnetron and reassembled.no problems at all
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RICHARD from Santa Rosa, CA
- Parts Used:
- WB39X75
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Bottom Of Oven Cracked
Removed broken bottom tray no tools needed slid new tray in, rather a tight fit because of the gaskets around the edges. The door now must be more firmly closed. Works fine. . Wife happy. . . . . . .
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Fort Myers, FL
- Parts Used:
- WB39X75
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Ceramic base in microwave split
Pulled old base up easily with screwdriver. Slipped new base in very easily. Perfect fit.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ernest from Riverview, MI
- Parts Used:
- WB27X10585
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers
oven made a loud buzzing & would not heat
completly removed outer cabinet,discharged capicator,removed some internal parts so I could get at the magnetron,
.removed replaced magnetron,reinstalled inner parts& cabinet .tested microwave viola
everything worked again.
Thanks, PartsSelect
Ernie
.removed replaced magnetron,reinstalled inner parts& cabinet .tested microwave viola
everything worked again.
Thanks, PartsSelect
Ernie
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Beverly from PARSIPPANY, NJ
- Parts Used:
- WB4X174
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Rack in freezer keep falling down.
The spacer just snapped onto the rack giving it a little more width to hold the shelf on the guides. Not the best fit but hopefully will do the trick long term. I thought it would have been a bigger part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alan from Bonita, CA
- Parts Used:
- WB27X10585
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
Stopped heating and had a banging noise
I took instant pictures at each step to make sure I put the wires back correctly. Removed the front panel. Discharged the capacitor with a voltage meter. Removed parts in front of the magnetron. Removed and replaced the magnetron. Reassembled. Works find now. Small hands, a flashlight and a magnet (for dropped screws) would help. I did not need the pictures.
Was this instruction helpful to you?
Thank you for voting!