Models > DVM1850DM2WW > Instructions

DVM1850DM2WW General Electric Microwave - Instructions

Jump to:

All Instructions for the DVM1850DM2WW
106 - 120 of 266
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Rick from Muncie, IN
Parts Used:
WB24X829
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
microwave Quit working but lights worked
llation
5 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sharon from BUDD LAKE, NJ
Parts Used:
WB02X10733
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
I was receiving message that charcoal filter needed replacing
I finally found the two screws to remove the fan opening. Once I did that I did not locate an OLD charcoal filter!! I just deducted there was never one in there, based on where the instructions said it should be located. I placed the new filter and let it "rest on an angle" as per the instructions I read from the diagram, and from the other peoples description online. I put the breaker back on and all seems fine!
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Erwin from CONROE, TX
Parts Used:
WB24X830, WB24X829
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers
Still runs even the door was open
Pulled it from the wall remove the front vent covers removed the control panel remove the door switches by a special screw driver bit which looks a star remove the electrical terminals pressed the plastic clip pulled the switch replaced it with new one then followed initial steps backward
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Edward from DENVER, NC
Parts Used:
WB26X10208, WB06X10144
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Turntable Replacement Motor was a larger diameter than the original
Drilled a new tap hole in the base-plate to match the larger diameter motor.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
WALTER from SEATTLE, WA
Parts Used:
WB02X10733
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
No problem in replacing the charcoal filter
I just followed your instructions that came with the filter removed the screws and slid the cover to the left
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Tommy from Santa clarita, CA
Parts Used:
WB36X10071
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Previoous glass lens was broken
This repair was easy and could be done by anyone. If you undertake to do this replacement, remember to slowly bend the medal tabs back that hold the lens. Handled roughly these tabs could break off.

This repair can be don in under 5 minutes, easily !!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Timothy from LAKE WALES, FL
Parts Used:
WB06X10144
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
The coupler broke , glass turntable not turning
Received part installed in less than one minute, easy fix alignment of part in shaft pressing down into position
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Timothy from MAYSVILLE, GA
Parts Used:
WB24X830
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Microwave would run but not heat
Removed the control panel, one screw at the top. Removed 2 screws on the door switch holder and removed the door switch. VERY EASY.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kathy from LEWISTON, MI
Parts Used:
WB06X10144
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The center of turn table broke. A small plastic part that goes under the glass in center.
We took out the broken part, it came right out,and put new part .
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
BRUCE from MONROE TWP, NJ
Parts Used:
WB06X10144
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
part was cracked
removed old part and replaced
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Gary from UNIVERSITY PA, MD
Parts Used:
WB36X10003
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
bulb burned out light that is under the microwave, which lights the oven below.
thank you for the video--very clear, responsible, applicable although the illustration was not exactly of our kind of light. the bulb was exactly like the one Hotpoint used in its microwave made in 1989! I will come back to you for parts in the future. (You have the model # from my original order.)
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Georgina from WAYNE, NJ
Parts Used:
WB06X10001
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
replace plastic ring in microwave
placed plastic ring under glass rotating plate in microwave
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Norman from Voorheesville, NY
Parts Used:
WB36X10071
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Broken lens
remove two screws bend out flaps remove broken glass install new glas bend flaps back to hold glass install two screws. Done.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lawrence from Cincinnati, OH
Parts Used:
WB02X10733
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Water dipenser valve leaking.
Replaced the filter cartridge.Problem solved.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Bonnie from Vandalia, IL
Parts Used:
WB02X10733
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Error message on readout said to change the filter
First I removed the two screws that held the filter cover in place, lifted out the old and replaced it with the new filter. Put the filter cover back on and replaced the two screws that hold it in place, and it was done in less than 5 minutes.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DVM1850DM2WW
106 - 120 of 266