GLMV169HBA Frigidaire Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Gregory from Boynton Beach, FL
- Parts Used:
- 5304441374
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Cracked, broken handle!
OK folks. Take a butter knife and pry the top and pop off the bottom. Literally less than 2 minutes! Simple. Fast. Easy. Fit perfect!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Russell from Greer, SC
- Parts Used:
- 5304441374
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Door Handle Broken
Took longer than it should due to no instructions being in box. The removal of the old door took approx 30 secs and was self explanatory. Once I realized I had to remove the plastic inner panel on the new door to re-install it, it also took only minutes. Could have been an easy fix with instructions.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carol from Framingham, MA
- Parts Used:
- 5304440335
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
annual replacement of filter
My husband did it by just taking off the panel on the top of the microwave and replace old with new. We cleaned up some of the accumulated grease as well on the microwave. He had a little problem with the screws. We have done this before so no big problem. Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Greg from Brighton, MI
- Parts Used:
- 5304441374
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Microwave door handle broken
After trying to bend parts that do not bend I realized you need to remove the plastic gasket around perimeter of microwave door but leave it loosely hanging on (pry off with screwdriver) With the gasket removed you can fit the door on and the snap the gasket back in place before closing and testing. The door was a perfect fit, it works great. The door will not go on until you remove or bend back that gasket. It's not obvious how or where to remove but just put a screwdriver in there and you'll feel it pop out and it snaps right back in after assembly..
Was this instruction helpful to you?
Thank you for voting!