GLMV169FPBB Frigidaire Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Genevieve from Lacey, WA
- Parts Used:
- 5304468175
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Cover was damaged
Slid old one out and slid new one in (under tabs).
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patrick from Jacksonville, FL
- Parts Used:
- 5304441374
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Front cracked by the handle. I already replaced handle.
The old door came off easy quick. the new door was a little different. I used a flat head screw driver, popped the bottom hinge in first and I did the same on the top. The top you had to use more pressure and use a little more force to rotate the hinge to the pin hole.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gregory from Boynton Beach, FL
- Parts Used:
- 5304441374
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Cracked, broken handle!
OK folks. Take a butter knife and pry the top and pop off the bottom. Literally less than 2 minutes! Simple. Fast. Easy. Fit perfect!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Greg from Brighton, MI
- Parts Used:
- 5304441374
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Microwave door handle broken
After trying to bend parts that do not bend I realized you need to remove the plastic gasket around perimeter of microwave door but leave it loosely hanging on (pry off with screwdriver) With the gasket removed you can fit the door on and the snap the gasket back in place before closing and testing. The door was a perfect fit, it works great. The door will not go on until you remove or bend back that gasket. It's not obvious how or where to remove but just put a screwdriver in there and you'll feel it pop out and it snaps right back in after assembly..
Was this instruction helpful to you?
Thank you for voting!